Brother International Innov-is VE2200 Operation Manual - Page 58

USING THE SENSOR PEN Calibrating the Sensor Pen Before using the sensor pen for the first time, be sure to personalize it using "Sensor Function Calibration" in the settings screen. Doing so allows the machine to learn the position in which you usually hold the pen. Hold the sensor pen at a comfortable angle and then calibrate the machine according to the procedure below. Be sure to keep the sensor pen at the same angle while calibrating the first and second points. d First touch the green dot marking on the needle plate cover using the sensor pen. * Touch on the needle plate cover. a Press . b Display page 3 of the settings screen. a Needle plate cover * A beep will sound and the a will change to red. (If you cannot hear the beep, check that the volume setting on page 1/7 of your settings is 1 or higher.) * Press to redo the first point by starting over from step d. e Touch the second point at the center cross-hair using the sensor pen. of the c Connect the then press sensor . pen to the machine and  The Sensor Function Calibration screen appears. * Touch on the point in the illustrations. B-56