Brother International IntelliFax-3550 Service Manual - Page 116
B Except for U.S.A., A for U.S.A.
View all Brother International IntelliFax-3550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
WSW21 (TAD setting 1) Selector No. Function 1 | Max. waiting time for voice signal 5 6 Two-way recording 7 Erasure of message stored in 8 the memory after the message transfer Setting and Specifications No. 1 2 3 4 5 0 0 0 0 0 : No detection 0 0 0 0 1 : 1 sec. 0 0 0 1 0 : 2 sec. 0 0 0 1 1 : 3 sec. | | 0 1 0 0 0 : 8 sec. | | 1 1 1 1 1 : 31 sec. No. 6 7 00 : 01 : 10 : 11 : A (for U.S.A.) B (Except for U.S.A.) C (without beep) D (OFF) 0: YES 1: NO q Selectors 1 through 5: Max. waiting time for voice signal In the TAD mode, the equipment waits for voice signal for the time length specified by these selectors before it automatically shifts to the facsimile message receive mode or disconnects the line. If the external TAD is connected to the equipment, the total length of the maximum waiting time specified by these selectors and the delay time specified by WSW25 (selectors 1 and 2) should not exceed 40 seconds. q Selectors 6 and 7: Two-way recording (For those models equipped with a built-in TAD) These selectors select the specifications of the two-way recording feature. q Selector 8: Erasure of message (For those models equipped with a built-in TAD) Setting this selector to "0" will erase the message recorded in the memory after the document retrieval feature transfers the message. WSW22 (Communications setting 1) Selector No. 1 | 4 Not used. Function 5 Acceptable TCF bit error rate (%) | (Only at 4800 bps) 8 Setting and Specifications 0: 0% 0: 0% 0: 0% 0: 0% 1: 8 % 1: 4 % 1: 2 % 1: 1 % q Selectors 5 through 8: Acceptable TCF bit error rate (%) Setting two or more selectors to "1" produces addition of percent assigned to each selector. If you set selectors 7 and 8 to "1," the acceptable TCF bit error rate will be 3%. V - 34