Brother International LK3-B430E MKII Instruction Manual - English - Page 15
. Installing the motor, Install the motor
View all Brother International LK3-B430E MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3. INSTALLATION 3-2 . Installing the motor q u Install the motor u to the work table with the four ac- cessory bolts q, cushions w, cushion collars e, flat q washers r, spring washers t and nuts y. At that time, fix by setting bolts q a little to the right of oval hole on motor. NOTE: Tighten the nuts y so that the clearance between the table and the cushion collars e is approximately 1 mm. w e r t y 1mm Table e 3-3 . Installing the motor pulley q w e Place the motor pulley q onto the shaft of the motor w so that the key groove is aligned, and then tighten the set screw e so that the center of the V groove in the motor pulley q is aligned as closely as possible with the center of the belt hole in the power table. 9 LK3-B430E-, B431E-, B432E-, B433E- Mark II