Brother International LK3-B431 MKII Instruction Manual - Page 69
Troubleshooting
View all Brother International LK3-B431 MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
16. TROUBLESHOOTING Problem Cause Check 16. TROUBLESHOOTING Remedy Page Presser does not rise. Work clamp operation is sluggish. Presser lifter amount is too great. Too much friction between presser plate and presser arm lever support. Sliding part of the work clamp lubrication Distance between work clamp and top of needle plate Presser plate and presser arm lever support lubrication __- Grease the sliging part of the work 36 clamp. Adjust the height of the work clamp to within 17 mm. 36 - 37 Grease the presser plate and presser arm 36 lever support. Presser does not drop. Presser is contacting _ Thread wiper standby thread wiper. position _ Presser lifter link is not moving back. Link return spring is unhooked. Adjust the position of the thread wiper. 39 Hook the link return spring properly. z Presser lift amount is incorrect. *2 Work clamp does not close. Thread wiper does not operate correctly. Incorrect position of Distance between presser arm lever - work clamp and top plate. of needle plate Incorrect position of presser closing roller. Whether stop lever is engaged with stop position adjustment bar or not The thread wiper is obstructing the needle. dClearance beween thread wiper and needle tip Thread wiper position is incorrect. Thread wiper position Adjust the work clamp lift amount. 36 - 37 Adjust the position of presser closing roller. 38 Adjust the height of the thread wiper. 39 Adjust the operating distance of the thread 39 wiper. Lower thread winds to one side. Bobbin winder thread tension stud height is incorrect. Bobbin winder thread tension stud height Adjust the height of the thread tension stud. 24 Lower thread winding amount is incorrect. Bobbin presser position is incorrect. Thread winding amount Adjust the position of the bobbin presser. 24 Threads comes unthreaded. Stitches being skipped at the sewing start. Refer to "Skipped stitches occur" Refer to "Skipped stitches occer". Uneven upper thread length. Upper thread length Adjust the subtension. 26 Upper thread is too short. Thread take-up lever stroke Adjust the thread take-up lever stroke. 34 *1 Not applicable for the B432E Mark II. *2 B432E Mark II only. 1K3-B430E-, B431E-, B432E-, 8433E- Mark it 62