Brother International LS-1520 Quick Setup Guide - English - Page 2
Caution - sewing machine
View all Brother International LS-1520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
D Cleaning bobbin case 1 CAUTION Troubleshooting ∗Do not pull or push fabric while stitching. It may bend the needle causing it to break. Remove the power plug from the outlet. ∗Do not turn the balance wheel and pull the fabric by force when the thread is entangled or the motor is locked. If the thread is entangled, remove the thread and fabric according to the procedure below. 2 3 4 5 1 2 Raise the needle to its highest position, pull the latch and remove the bobbin case. 6 Slide the latch levers out from the retaining ring. 7 Remove the retaining ring. Remove the hook by grasping the center post and pulling out. Note it's position related to the driver. 8 9 Open the hinged door and look for entangled thread. Cut the entangled thread with small scissors above the needle plate and then gently remove the thread and fabric. 3 4 Perform steps 1 through 8 of "Cleaning bobbin case". (See D.) Remove any accumulated lint and thread with a brush. Grasp the center post of the hook, match the hook position opposite the driver and insert. Insert the retaining ring with the notch up. Push the latch levers into their locked position. Replace the bobbin cace. (See A.) Turn the balance wheel to raise the needle, then remove the fabric. ∗If machine runs but needle does not move, look to be sure bobbin winding shaft is moved to the left into the sewing position. ***READ ME FIRST*** Should you encounter any problem with your product: *DO NOT RETURN THIS PRODUCT TO THE STORE *Please read the manual carefully. If you still need assistance, call 1-901-379-1010 for customer service. *For the address of your closest service center, call 1-800-284-4357. *KEEP ALL PACKING MATERIAL AND CARTON FOR FUTURE TRANSPORT. TO REPACK: FOLLOW DIAGRAM BELOW =REPACKING= 1 2 3 4 5 6 XA8545-021 PRINTED IN CHINA