Brother International LS2250PRW Users Manual - English and Spanish - Page 42
Bobbin case tension, adjustment
View all Brother International LS2250PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
APPENDIX Bobbin case tension adjustment The bobbin thread tension has already been adjusted at the factory for general use. For most sewing applications, no adjustment is needed. When sewing with thin thread on thin fabrics, the thread tension may not be adjusted adequately with the upper tension control dial. Therefore, the thread tension must be adjusted according to the procedure described below. Note ● Remember to return the screw to its original setting before starting your next project. ■ Bobbin tension is too loose Loops appear on the surface of the fabric. 1 2 3 a Wrong side b Surface c Upper thread d Lower thread e Loops appear on 5 surface of fabric 4 Solution Reduce the tension by turning the upper tensioncontrol dial to a lower number. ■ Bobbin tension is too tight Loops appear on the wrong side of the fabric. 1 5 2 3 4 a Wrong side b Surface c Upper thread d Lower thread e Loops appear on wrong side of fabric Solution Increase the tension by turning the upper tension- control dial to a higher number. Note ● If the loops still appear on the wrong side of the fabric after you adjust the upper tension, the bobbin thread may be too tight. In this case, turn the screw counterclockwise being careful not to over-loosen the screw, approximately 30-45 degrees to decrease bobbin tension. After you adjust the bobbin thread, adjust the upper thread to match the bobbin thread. Note ● If the loops still appear on the surface of the fabric after you adjust the upper tension, the bobbin thread may be too loose. In this case, turn the screw clockwise, being careful not to over-tighten the screw, approximately 30-45 degrees to increase bobbin tension. After you adjust the bobbin thread, adjust the upper thread to match the bobbin thread. a Screw a Screw 41