Brother International LS2400 Operation Manual - Page 17
Checking the needle, Replacing the needle
View all Brother International LS2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
CAUTION ● The appropriate fabric, thread and needle combinations are shown in the table on the previous page. If the combination of the fabric, thread and needle is not correct, particularly when sewing thick fabrics (such as denim) with thin needles (such as 65/9 to 75/11), the needle may bend or break. In addition, the stitching may be uneven or puckered or there may be skipped stitches. Checking the needle Sewing with a bent needle is extremely dangerous since the needle may break while the machine is being operated. Before using the needle, place the flat side of the needle on a flat surface and check that the distance between the needle and the flat surface is even. 1 2 Replacing the needle Replace the needle as described below. Use a coin and a needle that has been determined to be straight according to the instructions in "Checking the needle" . 1 Turn off the sewing machine. a CAUTION ● Before replacing the needle, be sure to turn off the sewing machine, otherwise injuries may occur if the foot controller is accidentally pressed and the machine starts sewing. Raise the needle to its highest position by b turning the handwheel toward you (counterclockwise). a Flat side b Needle type marking ■ Correct needle Lower the presser foot lever. c 1 a Flat surface ■ Incorrect needle If the distance between the needle and the flat surface is not even, the needle is bent. Do not use a bent needle. a Presser foot lever 1 a Flat surface 16