Brother International LT2-841 MKII Instruction Manual - Multi - Page 42
Preparation, Before, Sewing, Vorbereitungen, Nahen, Preparatifs, Avant, Couture, Preparativos, Antes
View all Brother International LT2-841 MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
6666....PPPVRRROEEERPPPBAAAERRRRAAAETTTIATBIIIOFVVAUESOANNNFZNTSOGUELTREMSDASENECEACWOHOUINESTNGEURRE 6-4-2. Installing the cap [B845, B848, B8751 6-4-2. Einsetzen der Spulenkapsel [B845, B848, B875] 6-4-2. Installation du capuchon [B845, B848, B8751 6-4-2. Instalacion de la tapa [B845, B848, B875] 50 mm 50 mm 50 mm 4 A„. A 1. Insert the bobbin 0 into the cap 0 so that the winding direction is as shown in the illustration. 2. Thread the thread by one of the following methods in accordance with the shape of the cap being used. 1) Pass the thread through slot ® and under the tension spring 0. 2) Pass the thread through slots C) and ©, and then through the thread-loosening-prevention spring 0. 3) Pass the thread through the thread hole 0 and pull out about 50 mm. 1. Setzen Sie die Spule 0 in der gezeigten Wickelrichtung in die Spulenkapsel 0 ein. 2. Fadeln Sie den Faden je nach der Form der verwendeten Spulenkapsel nach einer der folgenden Methoden ein. 1) Den Faden durch den Schlitz OA unter die Spannfeder 0 einziehen. 2) Den Faden durch die Schlitze C) und © und durch die Unterfaden-Spannfeder 0 fiihren. 3) Den Faden durch das Loch 0 fiihren und ca. 50 mm herausziehen. 1. Inserer la canette 0 dans le capuchon Ode maniere que la direction de bobinage soit comme indique sur ('illustration. 2. Enfiler le fil en utilisant l'une des methodes suivantes selon la forme du capuchon utilise. 1) Placer le fil dans la fente ® et sous le ressort de tension 0. 2) Passer le fil dans les fentes ® et © puis dans le ressort 0 qui empeche celui-ci de se relacher. 3) Passer le fil dans le trou 0 et tirer environ 50 mm. 1. Insertar Ia bobina 0 en la tapa 0 de manera que la direccien de enrollado sea la indicada en la figura. 2. Enhebrar el hilo mediante uno de los metodos indicados de acuerdo con la forma de la tapa usada. 1) Pasar el hilo a traves de la ranura C) y por debajo del muelle de tension 0. 2) Pasar el hilo a traves de las ranuras © y © y luego a traves del muelle de prevencien de flojedades en el hilo 0. 3) Pasar el hilo a traves del agujero del hilo 0 y sacar unos 50 mm. - 27 - Model No. LT2-B840 Mark II LT2-8870 Mark II