Brother International MFC-790CW Quick Setup Guide - English - Page 36

For Wireless Network Users 25 Configure the wireless settings using the automatic wireless (onepush) method a Confirm your wireless router or access point has the SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™ symbol as shown below. b Place the Brother machine within range of a SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™ access point/router. The range may differ depending on your environment. Refer to the instructions provided with your access point/router. c Push the SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™ button on your wireless router or access point. See the user's guide for your wireless router or access point for instructions. d On your machine, press MENU. Press a or b to display Network and press Network. Press WLAN. Press SES/WPS/AOSS. When Switch Network interface to wireless? is displayed, press Yes to accept. This will start the wireless setup wizard. To cancel, press No. This feature will automatically detect which mode (SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™) your access point uses to configure your machine. Note If your wireless access point supports Wi-Fi Protected Setup™ (PIN Method) and you want to configure your machine using the PIN (Personal Identification Number) Method, see Using the PIN Method of Wi-Fi Protected Setup™ in the Network User's Guide on the CD-ROM. e If the LCD shows Connected, the machine has successfully connected to your router or access point. You can now use your machine in a wireless network. If the LCD shows Setting WLAN, Connecting SES (Connecting WPS or Connecting AOSS), then Connection Failed, the machine has not successfully connected to your router or access point. Try starting from c again. If the same message is indicated again, reset the machine back to the default factory settings and try again. For resetting, see Restore the network settings to factory default on page 49. If the LCD shows Setting WLAN, then Connection Failed or Incorrect Mode, a session overlap or connection failure was detected. (see the table below), the machine has detected 2 or more routers or access points on your network that have the SecureEasySetup™, Wi-Fi Protected Setup™ mode or AOSS™ mode enabled. Make sure that only one router or access point has the SecureEasySetup™, Wi-Fi Protected Setup™ mode or AOSS™ mode enabled and try starting from c again. LCD messages when using the SES/WPS/AOSS control panel menu Setting WLAN Searching or accessing the access point and downloading settings from the access point. Connecting Connecting to the access SES/WPS/AOSS point. Connection Failed Connection failed. If this is shown after the LCD shows Connecting SES/WPS/AOSS, a session overlap was detected. Incorrect Mode A session overlap was detected. Connected The machine has successfully connected. Note If you encounter a problem during setup, temporarily place your machine closer to the wireless access point, and go back to c. Wireless setup is now complete. 36