Brother International MFC-8480DN Network Users Manual - English - Page 41

Configuring your machine for a wireless network (For MFC-8890DW) Configure your machine for a wireless network 3 IMPORTANT • If you are going to connect your Brother machine to your network, we recommend that you contact your system administrator prior to installation. You must know your wireless network settings before you proceed with this installation. • If you have previously configured the wireless settings of the machine, you must reset the network LAN 3 settings before you can configure the wireless settings again. Press Menu, 7, 0 for Network Reset, press 1 for Reset and then choose 1 for Yes to accept the change. The machine will restart automatically. Using the Setup Wizard from the control panel 3 You can configure your Brother machine by using the Setup Wizard function. This is located in the Network menu on the machine's control panel. See to the steps below for further information. a Write down the wireless network settings of your access point or wireless router. If you do not know them, contact your network administrator or the manufacture of your access point/router. Check and record the current wireless network settings. Network name:(SSID, ESSID) Communication Mode Infrastructure Authentication method Open system Ad-hoc Shared key WPA/WPA2-PSK 1 LEAP EAP-FAST/NONE EAP-FAST/MS-CHAPv2 EAP-FAST/GTC Open system Encryption mode WEP 2 NONE WEP 2 AES TKIP 3 CKIP AES TKIP Network key 4 - WEP 2 NONE - 31