Brother International MP-21C Quick Setup Guide - English - Page 6

A: INSTALLING THE PRINTER INTERFACE CARD If you are not going to use the printer through the Printer Interface Card, skip sections 'A'and 'B' and go straight to section 'C'. However, we recommend that you install the Printer Interface Card Driver at this point whether or not you intend to use the printer through the Printer Interface Card. ! Caution DO NOT remove the Printer Interface Card and the PC Card Cable when LEDs are on or blinking. Before you remove them, press the (On/Off) button and wait until all the LEDs are off.  Note • Before installing the Printer Interface Card Driver, check that your computer is connected to a live power source or your computer has enough battery power left. • If you remove the printer cable or turn the printer off while you are inserting the Printer Interface Card into the PC Card slot, and the printer does not work correctly after that, remove the Printer Interface Card from the slot and insert the card again and re-start the Printer Interface Card Driver installation. • Before you install the PC Card Driver, be sure to set the Power Save mode of your computer off. For details, see your computer's manual. Installing the Printer Interface Card Driver in Windows® 3.1 1. Make sure that the computer is turned off. 2. Connect the PC Card Cable to the Printer Interface Card. Insert the Printer Interface Card into the PC Card slot of your computer with the label side face up. Be sure to insert the card fully into the slot. Fig. 6 Inserting the Printer Interface Card 3. Turn your computer on and start Windows 3.1. 4