Brother International NX-650 Users Manual - English - Page 155
sewn correctly.
View all Brother International NX-650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
APPENDIX Symptom Probable Cause Remedy Dust has accumulated in the feed dogs or in the bobbin case. Clean the race. A high-pitched noise is made while sewing. The upper thread was not threaded correctly. The bobbin case is scratched, or has a burr on it. Correct the upper threading. Replace the bobbin case. Contact your dealer or the nearest authorized service center. A bobbin designed specifically for this machine is not used. Incorrect bobbins will not work properly. Only use a bobbin designed specifically for this machine. The needle threader cannot be used. The needle has not been raised to the correct position. The needle is incorrectly installed. Press the "Needle Position" button. Correctly install the needle. The presser foot that is used is not Attach the presser foot that is appropriate for the type of stitch that appropriate for the type of stitch you wish to sew. that you wish to sew. The stitch is not sewn correctly. The thread tension is incorrect. Adjust the tension of the upper thread. The thread is tangled, for example, in the bobbin case. Remove the tangle thread. If the thread is tangled in the bobbin case, clean the race. The feed dogs are lowered. Slide the drop feed lever to the right. (as seen from the rear of the machine) The stitch is too short. Lengthen the stitch length. The fabric does not feed. The presser foot that is used is not appropriate for the type of stitch that you wish to sew. The pressure of the presser foot is weak. Attach the presser foot that is appropriate for the type of stitch that you wish to sew. Turn the presser foot pressure dial to the left to increase the pressure of the presser foot. The thread is tangled, for example, in the bobbin case. Remove the tangle thread. If the thread is tangled in the bobbin case, clean the race. The sewing lamp does not come on. The sewing lamp is damaged. Contact your dealer or the nearest authorized service center. Nothing appears in The brightness of the LCD is either the LCD. too light or too dark. Adjust the brightness of the LCD. Reference page 149 page 28 - page 22 page 31 page 39 page 138 page 57 page 149 page 105 page 60 page 138 page 43 page 149 - page 156 154