Brother International PE-170D Owner's Manual (Español) - Spanish - Page 66
Using A Small, Using A Large
View all Brother International PE-170D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
CONTENTS MACHINE KNOWLEDGE EMBROIDERING MAINTENANCE ERROR MESSAGE TROUBLESHOOTING Symptom Probable cause Remedy 5. Lower thread is visible on the top surface of the fabric 1. The upper thread tension is too strong. 1. Decrease the upper thread tension using the upper thread tension dial. 2. The upper or lower thread is not threaded correctly. 2. Thread the upper and lower threads correctly. 3. The thread has been threaded incorrectly through the inner rotary hook. 3. Remove the bobbin, reset the bobbin properly and pull the bobbin thread through the channel. 4. A thread other than the designated 4. Replace with the designated lower lower embroidery thread is being used. embroidery thread. 6. Upper thread is loose 1. The upper thread tension is too weak. 1. Increase the upper thread tension using the upper thread tension dial. 2. The upper or lower thread is not threaded correctly. 2. Thread the upper and lower threads correctly. 3. Threads other than the designated 3. Replace with the designated upper and upper and lower embroidery thread are lower embroidery threads. being used. 7. Embroidered pattern is out of shape 1. The fabric has been placed in the embroidery frame incorrectly. 1. Place the fabric in the embroidery frame correctly. 2. The embroidery frame has been attached to the machine incorrectly. 2. Attach the embroidery frame to the machine correctly. 3. Thin or stretch fabric is being used with 3. Attach stabilizer fabric. no stabilizer fabric attached. 4. Threads other than the designated 4. Replace with the designated upper and upper and lower embroidery thread are lower embroidery threads. being used. 5. The thread is tangled. 5. Cut and remove the tangled threads inside the rotary hook using scissors. Clean the race or inner rotary hook. 8. Threading is not possible 1. The needle is installed incorrectly. 1. Install the needle correctly. 2. The needle threader lever will not turn. 2. Turn the balance wheel to raise the needle to its highest position. 9. Thread is not cut during automatic thread cutting. 1. Thread has accumulated around the thread cutting knife. 1. Remove the needle plate and clean away the accumulated thread. PATTERNS EMBROIDERING USING A SMALL FRAME (OPTIONAL) EMBROIDERING USING A EXTRA-SMALL FRAME (OPTIONAL) EMBROIDERING USING A LARGE FRAME (OPTIONAL) 63