Brother International PR655 Installation Guide for KIT CW PRCW1 - Page 24
Step 2] Upgrading the USB Card, Writer Module
View all Brother International PR655 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
CASE 1: When PE-DESIGN NEXT is not installed on the computer f Check the installation location, and then click "Next". h Click "Finish" to complete the installation of the software. Memo • To install the application into a different folder: 1. Click "Change". 2. In the "Change Current Destination Folder" dialog box that appeared, select the drive and folder. (If necessary, type in the name of a new folder.) 3. Click "OK". - The "Run" dialog box appears. 4. Click "Next" to install the application into the selected folder. • To return to the previous dialog box, click "Back". • To cancel the installation, click "Cancel". → A dialog box appears, indicating that preparations for installation are finished. g Click "Install" to install the application. → When the installation is completed, the following dialog box appears. Memo • If the dialog box calling for restarting the computer appears, it is necessary to restart the computer. [Step 2] Upgrading the USB Card Writer Module In order to use PE-DESIGN NEXT + CW, the USB card writer module must be upgraded after the software has been upgraded. If the software is updated from PE-DESIGN version 5 through 8, the Upgrade Wizard starts up immediately after you launch Layout & Editing. Follow the wizard instructions to upgrade the USB card writer module. If PE-DESIGN NEXT is already being used with a different computer and the Upgrade Wizard does not start up, continue with [Step 2] in CASE 2. Note • It may not be possible to upgrade if a firewall is turned on. Temporarily turn off the firewall, and then try performing the operation again. • Each product ID is valid for only one USB card writer module. A product ID that has already been used cannot be used with a different USB card writer module. • Do not connect more than one USB card writer module to the computer at a time. • If the USB card writer module is not upgraded, it can only be used the limited number of times that the software can be used. Be sure to upgrade the USB card writer module using the following steps. a Connect the USB card writer module to the computer's USB port, and then start Layout & Editing. → The dialog box shown below appears. 20