Brother International PR670E Table Set Installation Manual PRWT1 - Page 4
Installing the table
![]() |
View all Brother International PR670E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Installing the table Loosen the two thumb screws 5 to 6 turns. 1 Slide in the table while supporting it so that 4 it remains level. Push the table in until it lightly touches the machine. • If the table does not move smoothly, slightly lift it up, and then slide it in. Position the table so that the notch at the 2 center aligns with the machine bed, and then place the table flat on the guide plates. While looking below the table, lightly lift it 5 up, and then lower it so that the screw fits into the notch at the front of the guide plate. 1 Notch in table 2 Machine bed 3 Guide plate Pull the table toward you slowly, until the 3 pins on the mounting brackets (attached on each side to the bottom of the table) fit into the notches in the guide plates. 1 Notch at front Tighten the two thumb screws so that the 6 table is secured. 1 Pin 2 Notch 1 Thumb screw 3/4
![](/manual_guide/products/brother-international-pr1000-table-set-installation-manual-prwt1-3a850d9/4.png)