Brother International PT-9200DX Quick Setup Guide - English and Spanish - Page 14
For a USB connection Windows, Me/2000 Peofessional/XP only - xp drivers
View all Brother International PT-9200DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
For Windows® 4 Select the desired baud rate, and then click the Next button. Normally "115,200 bps" is selected; however, your computer may not be able to support a baud rate of 115,200 bps. If this is the case, refer to the your computer's instruction manual and select the maximum possible baud rate. A dialog box appears, asking for confirmation of the selected baud rate settings. For a USB connection (Windows® 98/Me/2000 Peofessional/XP only) With Plug-and-Play, new devices connected to the system are detected, and their drivers are automatically installed. If the PT-9200DX is to be connected through the USB port, its driver will be installed with Plug-and-Play. Be sure to read the installation instructions described below before installing the file supplied on the CD-ROM. Do not connect the P-touch 9200DX to the computer until you are instructed to do so, otherwise the PT-9200DX printer driver may not be installed correctly. With Windows® 98/98SE/Me/2000 Professional: 1 Select "USB cable", and then click the OK button. The USB message dialog box appears. 5 Check that the baud rate will be changed as desired, and then click the Next button. To change the settings, click the Back button, and return to step 4. A dialog box appears, showing that the baud rate has been set as specified. 2 Click the Next button. A dialog box appears, instructing you to connect the PT-9200DX to the computer. 6 Click the Finish button. 3 Connect the PT-9200DX to the computer using the enclosed USB interface cable as described on page 5, and then turn on the PT-9200DX. A dialog box appears, showing that the printer driver has been installed. 10