Brother International PocketJet 6 Plus Print Engine User Guide - Page 7
Charging the Rechargeable, Ni-MH Battery
View all Brother International PocketJet 6 Plus Print Engine manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
d Grasp the battery removal ribbon, which is attached to the inside of the battery compartment. Make sure that enough ribbon is exposed after the rechargeable Ni-MH battery installed so that you can pull the ribbon to remove the battery. e While holding onto the ribbon, tilt the rechargeable Ni-MH battery and insert it into the battery compartment. After the rechargeable Ni-MH battery passes the outer edges of the compartment, press it securely into position. Note • Make sure that the side of the rechargeable Ni-MH battery marked "Ni-MH" faces away from the battery compartment, otherwise the battery cover will not close properly. • The rechargeable Ni-MH battery contains a heat sensor that stops the flow of electricity if the battery overheats. f Attach the battery cover to the end of the battery compartment opposite the AC/DC connector. Close and latch the cover. If necessary, gently push the cover latch towards the AC/DC connector until it latches. Note • Be careful that you do not pinch the battery connector cord. • The voltage supplied by the rechargeable Ni-MH battery fluctuates. The printing speed may also fluctuate depending on the voltage. Removing the Rechargeable Ni-MH Battery 1 a Open the battery cover by pressing the cover latch. b Swing the cover open and remove it. Setting Up the Printer c Gently pull the battery removal ribbon until the rechargeable Ni-MH battery starts to tilt out of its compartment. 1 1 1 Battery removal ribbon Note If the battery removal ribbon is caught behind the rechargeable Ni-MH battery, insert a thin metal object such as a flat-blade screwdriver between the battery and the case at the end away from the AC/DC connector and tilt it out of its compartment. d Remove the rechargeable Ni-MH battery from the compartment. e Gently pull the rechargeable Ni-MH battery connector and remove it from the terminal inside the printer. Charging the Rechargeable Ni-MH Battery 1 Perform the following procedure to charge the rechargeable Ni-MH battery. Note • Charge the rechargeable Ni-MH battery immediately after purchase using the following procedure. • Up to 120 minutes is needed to fully charge a rechargeable Ni-MH battery. About 70 pages can be printed when using a new, fully-charged rechargeable Ni-MH battery. 3