Brother International TD-2135N Raster Command Reference - Page 15

Raster Command Reference Descriptions for the numbers in the print data on the previous page are provided in the following table. For details on each command, refer to "4. Printing Command Details". No. Command Name Description １ Invalidate A 200-byte invalidate command is sent. 2 Initialize The "initialize" command is sent. 3 Switch dynamic command mode The printer is switched to raster mode. Send this command before sending raster data to the printer. 4 Job ID setting commands Internal specification commands Since this is a command for outputting with the commercial version driver, it is unnecessary for the user to send this command. 5 Additional media Additional media information on the media size is sent. information command This is the command for "2.0" × 1.0" (51 mm × 26 mm)". 6 Print information command Media size information for the print data is sent. This is the command for "2.0" × 1.0" (51 mm × 26 mm)" die-cut labels. 7 Various mode settings This is a command for specifying a mode. (1Bh+69h+4Dh+00H) In this case, the peeler function is enabled. 8 Specify margin amount Since a margin amount cannot be specified with die-cut labels, this command is sent with a margin amount of 0. 9 Select compression mode TIFF compression mode is selected. 10 Raster data Raster data continues. 11 Print command with feeding Since one page will be printed, this is sent at the end of the first page. - 11 - 2. Print Data