Brother International TD-4520DN ESC/ P Command Reference - Page 89
Symbol Size, X Direction
View all Brother International TD-4520DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
ESC/P Command Reference 8. Aspect value [2-byte decimal] 1-1000 Specifies the aspect value. Actually, this is 0.01-10.0, but since the decimal point cannot be entered, a value multiplied by 100 is entered. The default value is 50. (The actual value is 0.5.) Note * Some barcode readers cannot recognize a barcode with the cell size specified as 1 dot or 2 dots. * If a setting for the symbol size (X direction) or symbol size (Y direction) has been specified manually, the aspect value setting is ignored. * If a setting for the symbol size (X direction) or the symbol size (Y direction) has been entered manually, the bar code may not be printed or an unreadable bar code may be printed. * If both a large cell size and a high level error correction capacity have been specified, printing may not be possible due to a full print buffer. [With symbol type MicroPDF417] * Since the error correction capacity is automatically determined from the symbol size (X direction) setting, the settings for "error correction capacity and type" and "error correction capacity-value" are ignored. * The aspect value setting is ignored. * The following table shows the values available for the symbol size (Y direction) according to the symbol size (X direction) setting. If an invalid setting is specified for the symbol size (Y direction), the default setting is specified. Symbol Size (X Direction) Symbol Size (Y Direction) Auto Auto 1 Auto 11 14 17 20 24 28 2 Auto 8 11 14 17 20 23 26 3 Auto 6 8 10 12 15 20 26 32 38 44 4 Auto 4 6 8 10 12 15 20 26 32 38 44 (2) Barcode data The numbers of barcode data characters that can be entered are as follows. 1850 alphanumeric characters, 2710 numbers, 1108 binary bytes Note The numbers listed above are for an error correction level at a high-density level (L 7%). If the standard level or higher is set, the number of characters that can be entered may decrease. In addition, even if the characters are entered with the high-density level (L) specified, the number of characters that can be entered may decrease due to compression. - 83 - 5. Control Command Details