Brother International XL-3100 Users Manual - English and Spanish - Page 10
THREADING, MACHINE, Enhebrado, maquina
View all Brother International XL-3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
1d3S00 30 VN1110V141ns VOZONO3 . fl •A DNIM• NN KNOWING YOUR SEWING MACHINE CONOZCA SU MAQUINA DE COSER THREADING THE MACHINE Winding the bobbin 1. Change the Clutch Release Switch from the needle mark to the bobbin mark. 2. Place a spool of thread onto the horizontal spool pin and firmly hold it with a spool holder so that the spool of thread will not turn. Pass the thread through the thread guide as shown following the dotted line on the machine. 3. Pass the end of the thread through the hole on the bobbin from the inside. (1) Clutch Release Switch Bobbin winding Enhebrado de la maquina Bobinado de la canilla 1. Cambie elconmutadorbobina-aguja de la marca aguja a la marca canilla. 2. Coloque un carrete de hilo en el eje horizontal previsto y mantengalo firmemente con un tope para que no de vueltas. Pase el hilo por la guia, siguiendo la linea de puntos marcada en la maquina. 3. Pase elextremo delhiloporelorificio de la canilla a partir del nterior. (1) Conmutador Bobinado de la canilla co 0 ••1 4. Place the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the right. Turn the bobbin clockwise, by hand, until the spring on the shaft slides into the slit on the bobbin. 5. While holding the end of the thread, gently depress the foot controller to wind the thread around the bobbin a few times. Then stop the machine. 6. Trim the excess thread above the bobbin. Continue winding the thread onto the bobbin by depressing the foot controller. NOTE: The machine stops automatically when the bobbin is full. 7. Cut the thread, push the shaft to the left and remove the full bobbin from the shaft. 8. Return the Clutch Release Switch back to the needle mark. ® Spring ® Slit 4. Coloque la canilla en el eje de bobinado correspondiente y deslice dicho eje hacia la derecha. Gire la canilla en el sentido de las manecillas de un reloj, con la mano, hasta que el muelle impulsor del eje se deslice dentro de la ranura de la canilla. 5. Sujetando el extremo del hilo, presione suavemente elpedalpara que el hilo de vueltas alrededor de la canilla. Luego pare la maquina. 6. Deshaga el exceso de hilo arriba de la canilla. Siga bobinando el hilo en la canilla presionando el pedal. NOTA: La maquina se para automaticamente cuando la canilla esta Ilena. 7. Corte el hilo, empuje el eje hacia la izquierda y retire la canilla Ilena. 8. Vuelva a colocar el conmutador en la marca aguja. () Muelle ® Ranura 4 4 3 13 14