Browning Gold 20 Owners Manual - Page 13
How To Assemble The Barrel To, The Receiver - ga shotgun
View all Browning Gold 20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
HOW TO ASSEMBLE THE BARREL TO THE RECEIVER The Gold shotgun is delivered in the box, with the barrel removed and the forearm still attached to the magazine tube. It is important to follow the exact sequence for assembly in steps 1 and 2, in order to properly assemble your Gold shotgun. Always place the safety in the "on safe" position before assembly procedures and check your gun carefully to be certain that the chamber, feed mechanism and magazine contain no shells. 1 Take the receiver in hand. First, lock the bolt rearward by pulling the operating handle fully to the rear. Remove the forearm from the magazine tube by unscrewing the magazine cap and sliding the forearm forward, off the magazine tube. Do not squeeze hard on the open rear end of the forearm. Too much pressure could cause the wood to split. 2 Components of the gas system - the sleeve, sleeve spring and gas piston will remain in place and do not need to be removed, except for cleaning. If the components of the gas system have been removed, reinstall them as explained below. Otherwise, proceed to step 5. 3 Slide the sleeve onto the magazine tube with the piston rod end first. Check the piston rod to make sure it is aligned with the slot on the right side (ejection port side) of the receiver. Make sure the sleeve spring is properly positioned in the sleeve (Figure 3). FIGURE 3 4 Slide the gas piston into the gas bracket (Figure 3-A). Align the piston rod with the slot in the receiver. 11