Canon 2011B002 EOS-1Ds Mark III Instruction Manual - Page 171

3 Custom Function Settings C.Fn III -10 Switch to registered AF point You can instantly switch to the registered AF point with while the metering timer is active. (AF is activated at the moment when AF point is switched.) 0: Disable 1: Enable By pressing , you can switch to the registered AF point. Press it again to switch to the previous AF point. Registering the AF point (Multiple AF points cannot be registered.) You can register an AF point you use frequently. 1. Select the AF point to be registered. (p.84) 2. While holding down the button, press the button. • [ - - ] HP : Automatic selection, SEL [ ] : Center AF point, SEL HP : Off-center AF point If you change the C.Fn III -9 setting, the registered AF point will be canceled. The camera will switch to the center AF point. C.Fn III -11 AF point auto selection For AF point selection, you can enable or disable automatic selection. The setting before the slash (/) applies to the dial's function with C.Fn IV -3-1 set. And the setting after the slash applies to the dial's function when the button is pressed. 0: 5direct:disable/6:enable When metering is active, the dial cannot select automatic selection. You can select automatic selection with . 1: 5direct:disable/6:disable Automatic selection cannot be selected. 2: 5direct:enable/6:enable When metering is active, the dial can select automatic selection. You can select automatic selection with . C.Fn III -12 AF point display during focus 0: On 1: Off The AF point will not light in red other than during AF point selection. 2: On (when focus achieved) The manually selected AF point will not dimly light during autofocusing. (The AF point will light only when AF is started or focus is achieved.) 171