Canon Color imageCLASS MF641Cw Color imageCLASS MF644Cdw/MF642Cdw/MF641Cw Gett - Page 36

Appendix Users in the U.S.A. In Case of Equipment Malfunction [NOTE] Pre-Installation Requirements for Canon Should any malfunction occur which cannot be Canon recommends an individual line following Facsimile Equipment corrected by the procedures described in this industry standards, i.e., 2,500 (touch-tone) or 500 A. Location guide or the User's Guide, disconnect the (rotary/pulse dial) telephones. A dedicated Supply a suitable table, cabinet, or desk for the equipment from the telephone line cable and extension off a PBX (Private Branch eXchange) machine. See the User's Guide for specific disconnect the power cord. unit without "Call Waiting" can be used with your dimensions and weight. The telephone line cable should not be facsimile unit. Key telephone systems are not reconnected or the power switch turned ON recommended because they send nonstandard B. Order Information until the problem is completely resolved. Users signals to individual telephones for ringing and 1. A single telephone line (touch-tone or rotary) should contact Canon Authorized Service special codes, which may cause a facsimile error. should be used. 2. Order an RJ11-C telephone wall jack (USOC), which should be installed by the telephone company. If the RJ11-C wall jack is not present, telephone/facsimile operation is not possible. Facilities for servicing of equipment, Information regarding Authorized Service Facility locations can be obtained by calling Canon Customer Care Center (1-800-OK-CANON). C. Power Requirements The power outlet should be a three-prong grounded receptacle (Single or Duplex). It should be independent from copiers, heaters, air 3. Order a normal business line from your Rights of the Telephone Company conditioners, or any electric equipment that is telephone company's business representative. If this equipment (Color imageCLASS MF644Cdw) thermostatically controlled. The rated value is The line should be a regular voice grade line causes harm to the telephone network, the 115 volts and 15 amperes. The CA11A modular or an equivalent one. Use one line per unit. telephone company may temporarily disconnect jack should be relatively close to the power DDD (Direct Distance Dial) line service. The telephone company also retains the outlet to facilitate installation. -or- right to make changes in facilities and services [Notice] IDDD (International Direct Distance Dial) line if that may affect the operation of this equipment. • The REN of this product is 1.0. you communicate overseas When such changes are necessary, the • Before installing this equipment, users should [NOTE] Canon recommends an individual line following industry standards, i.e.,2,500 (touch-tone) or 500 (rotary/pulse dial) telephones. A dedicated extension off a PBX (Private Branch eXchange) unit without "Call Waiting" can be used with your facsimile unit. Key telephone systems are not telephone company is required to give adequate prior notice to the user. However, if advance notice is not possible, the telephone company will notify the customer as soon as possible. Also, the customer will be advised of his/her right to file a complaint with the FCC if he/she believes it is necessary. ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the company's inside wiring associated with a single line individual service may be recommended because they send nonstandard WARNING extended by means of a certified connector signals to individual telephones for ringing and The Telephone Consumer Protection Act of 1991 assembly (telephone extension cord). The special codes, which may cause a facsimile error. makes it unlawful for any person to use a computer customer should be aware that compliance C. Power Requirements The machine should be connected to a standard 120 volt AC, threewire grounded outlet only. Do not connect this machine to an outlet or power line shared with other appliances that cause "electrical noise." Air conditioners, electric typewriters, copiers, and machines of this sort generate electrical noise that often interferes with communications equipment and the sending and receiving of documents. or other electronic device, including FAX machines, to send any message unless such message clearly contains in a margin at the top or bottom of each transmitted page or on the first page of the transmission, the date and time it is sent and an identification of the business or other entity, or other individual sending the message and the telephone number of the sending machine or such business, other entity, or individual. (The telephone number provided may not be a 900 number or any other number for which charges exceed local or with the above conditions may not prevent deterioration of service in some situations. • Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. Connection of the Equipment long-distance transmission charges.) • Users should ensure for their own protection This equipment complies with Part 68 of the FCC that the electrical ground connections of the rules and the requirements adopted by the [NOTE] power utility, telephone lines, and internal ACTA. On the rear panel of this equipment is a In order to program this information into your metallic water pipe system, if present, are label that contains, among other information, a machine, you should complete the procedure connected together. This precaution may be product identifier in the format for registering your name, unit's telephone particularly important in rural areas. US:AAAEQ##TXXXX. If requested, this number number, time, and date in the Getting Started. must be provided to the telephone company. Users in Canada CAUTION The REN is used to determine the number of Pre-Installation Requirements for Canon Users should not attempt to make such devices that may be connected to a telephone Facsimile Equipment connections themselves, but should contact the line. Excessive RENs on a telephone line may result in the devices not ringing in response to A. Location Supply a suitable table, cabinet, or desk for the appropriate electric inspection authority, or electrician, as appropriate. an incoming call. In most, but not all areas, the machine. See the User's Guide for specific [NOTE] sum of RENs should not exceed five (5.0). dimensions and weight. This equipment complies with the Canadian To be certain of the number of devices that may ICES-003 Class B limits. En be connected to a line, as determined by the B. Order Information English This product meets the applicable total RENs, contact the local telephone company. 1. A single telephone line (touch-tone or rotary) Innovation, Science and Economic Development For products approved after July 23, 2001, the should be used. Canada technical specifications. REN for this product is part of the product 2. Order a CA11A modular jack, which should be The Ringer Equivalence Number (REN) indicates identifier that has the format US: installed by the telephone company. If the the maximum number of devices allowed to be AAAEQ##TXXXX. CA11A jack is not present, installation cannot connected to a telephone interface. The The digits represented by ## are the REN without occur. termination of an interface may consist of any a decimal point (e.g., 03 is a REN of 0.3). 3. Order a normal business line from your combination of devices subject only to the An FCC compliant telephone line cable and telephone company's business representative. requirement that the sum of the RENs of all the modular plug is provided with this equipment. The line should be a regular voice grade line devices not exceed five. This equipment is designed to be connected to or an equivalent one. Use one line per unit. Français [ French ] Le présent produit est the telephone network or premise wiring using a compatible modular jack that is Part 68 compliant. This equipment may not be used on coin service provided by the telephone company. DDD (Direct Distance Dial) line -orIDDD (International Direct Distance Dial) line if you communicate overseas conforme aux spécifications techniques applicables d'Innovation, Sciences et Développement économique Canada. L'indice d'équivalence de la sonnerie (IES) sert à indiquer le nombre maximal de dispositifs qui Connection to party lines is subjected to state peuvent être raccordés à une interface tariffs. téléphonique. La terminaison d'une interface peut consister en une combinaison quelconque de dispositifs, à la seule condition que la somme des IES de tous les dispositifs n'excède pas cinq. 36