Canon Color imageCLASS X MF1127C Getting Started Guide - Page 26

Appendix C. Power Requirements WARNING with the above conditions may not prevent The machine should be connected to a standard The Telephone Consumer Protection Act of 1991 deterioration of service in some situations. 120 volt AC, three-wire grounded outlet only. makes it unlawful for any person to use a • Repairs to certified equipment should be Do not connect this machine to an outlet or computer or other electronic device, including made by an authorized Canadian power line shared with other appliances that FAX machines, to send any message unless such maintenance facility designated by the cause "electrical noise." Air conditioners, electric message clearly contains in a margin at the top supplier. Any repairs or alterations made by typewriters, copiers, and machines of this sort or bottom of each transmitted page or on the the user to this equipment, or equipment generate electrical noise that often interferes first page of the transmission, the date and time malfunctions, may give the with communications equipment and the it is sent and an identification of the business or telecommunications company cause to sending and receiving of documents. other entity, or other individual sending the request the user to disconnect the Connection of the Equipment This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the rear panel of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number message and the telephone number of the sending machine or such business, other entity, or individual. (The telephone number provided may not be a 900 number or any other number for which charges exceed local or long distance transmission charges.) [NOTE] equipment. • Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines, and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. must be provided to the telephone company. In order to program this information into your CAUTION The REN is used to determine the number of machine, you should complete the procedure Users should not attempt to make such devices that may be connected to a telephone for registering your name, unit's telephone connections themselves, but should contact the line. Excessive RENs on a telephone line may number, time, and date as described in Setting appropriate electric inspection authority, or result in the devices not ringing in response to Up or Basic Operations in the User's Guide. electrician, as appropriate. an incoming call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total Users in Canada Pre-Installation Requirements for Canon Facsimile Equipment [NOTE] This equipment complies with the Canadian ICES-003 Class B limits. RENs, contact the local telephone company. For A. Location English This product meets the applicable products approved after July 23, 2001, the REN Supply a suitable table, cabinet, or desk for the Innovation, Science and Economic Development for this product is part of the product identifier machine. See the User's Guide for specific Canada technical specifications. that has the format US:AAAEQ##TXXXX. The dimensions and weight. The Ringer Equivalence Number (REN) indicates En digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3). An FCC compliant telephone line cable and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premise wiring using a compatible modular jack that is Part 68 compliant. This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subjected to state tariffs. B. Order Information 1. A single telephone line (touch-tone or rotary) should be used. 2. Order a CA11A modular jack, which should be installed by the telephone company. If the CA11A jack is not present, installation cannot occur. 3. Order a normal business line from your telephone company's business representative. The line should be a regular voice grade line or an equivalent one. Use one line per unit. the maximum number of devices allowed to be connected to a telephone interface. The termination of an interface may consist of any combination of devices subject only to the requirement that the sum of the RENs of all the devices not exceed five. Français [ French ] Le présent produit est conforme aux spécifications techniques applicables d'Innovation, Sciences et Développement économique Canada. L'indice d'équivalence de la sonnerie (IES) sert à indiquer le nombre maximal de dispositifs qui DDD (Direct Distance Dial) line peuvent être raccordés à une interface In Case of Equipment Malfunction -or- téléphonique. La terminaison d'une interface Should any malfunction occur which cannot be IDDD (International Direct Distance Dial) line if peut consister en une combinaison quelconque corrected by the procedures described in the you communicate overseas de dispositifs, à la seule condition que la somme User's Guide, disconnect the equipment from the telephone line cable and disconnect the [NOTE] des IES de tous les dispositifs n'excède pas cinq. power cord. The telephone line cable should not Canon recommends an individual line following be reconnected or the main power switch turned ON until the problem is completely About This Manual industry standards, i.e., 2,500 (touch-tone) or 500 (rotary/pulse dial) telephones. A dedicated resolved. Users should contact their local extension off a PBX (Private Branch eXchange) authorized Canon Facsimile Service Dealer for unit without "Call Waiting" can be used with your Trademarks the servicing of equipment. facsimile unit. Key telephone systems are not QR Code is a trademark of DENSO WAVE If your equipment malfunctions, please contact recommended because they send nonstandard INCORPORATED. your local authorized Canon dealer from whom signals to individual telephones for ringing and All brand names and product names appearing on you purchased the equipment (if under special codes, which may cause a facsimile error. this manual are registered trademarks or warranty), or with whom you have a servicing C. Power Requirements trademarks of their respective owners. contract. If you are not sure who to contact, and The power outlet should be a three-prong have both purchased and are using the equipment in the U.S.A., please refer to the Third Party Software grounded receptacle (Single or Duplex). It should be independent from copiers, heaters, air "SUPPORT" page on Canon U.S.A.'s Web site conditioners, or any electric equipment that is (http://www.usa.canon.com). thermostatically controlled. The rated value is This Canon product (the "PRODUCT") includes Rights of the Telephone Company If this equipment (imageCLASS X MF1127C) causes harm to the telephone network, the 115 volts and 15 amperes. The CA11A modular jack should be relatively close to the power outlet to facilitate installation. third-party software modules. Use and distribution of these software modules, including any updates of such software modules telephone company may temporarily disconnect [Notice] (collectively,the "SOFTWARE") are subject to service. • The REN of this product is 1.0. license conditions below. The telephone company also retains the right to • Before installing this equipment, users should (1) You agree that you will comply with any make changes in facilities and services that may ensure that it is permissible to be connected applicable export control laws, restrictions or affect the operation of this equipment. When to the facilities of the local regulations of the countries involved in the such changes are necessary, the telephone telecommunications company. The event that the PRODUCT including the company is required to give adequate prior equipment must also be installed using an SOFTWARE is shipped, transferred or notice to the user. However, if advance notice is acceptable method of connection. In some exported into any country. not possible, the telephone company will notify cases, the company's inside wiring associated the customer as soon as possible. Also, the with a single line individual service may be customer will be advised of his/her right to file a extended by means of a certified connector complaint with the FCC if he/she believes it is assembly (telephone extension cord). The necessary. customer should be aware that compliance 26