Canon D17-3712-251 GL1 Instruction Manual - Page 86
Setting the Audio Mix
UPC - 013803605938
View all Canon D17-3712-251 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Setting the Audio Mix E OFF CAMERA VCR POWER MIX AUDIO BALANCE MONITOR ST-1 ST-2 When you play back a tape that was recorded in 12-bit mode, you can set the audio output to play: stereo 1 (the original sound), stereo 2 (any new sound, dubbed to the tape after recording), or mix the balance between the two. • Audio from the 16-bit mode only contains stereo 1 sound and so you cannot/do not need to select the audio mix. The same is true for the 12-bit stereo 1 mode, unless new sound has been added postrecording. • You can choose the output using the wireless controller only. 1. Set the camera to VCR mode. 2. Choose the output. • Press AUDIO MONITOR on the wireless controller. • Four settings appear as you push the button: - STEREO1 for just stereo 1. - STEREO2 for just stereo 2. - MIX/FIXED for an equal mix of stereo 1 and 2. - MIX/VARI. (mix variable) for when you want to mix the balance between stereo 1 and 2. • To simply choose STEREO1, STEREO2 or MIX/FIXED, make sure your choice appears on the display. • If you choose MIX/VARI., you can go on to mix the balance. • Use the ST-1/ST-2 keys to mix the balance. A bar showing the mix appears on the screen for four seconds. Notes: • When you have chosen the output, STEREO1, STEREO2, MIX/FIXED or MIX/VARI. is shown in the top left of the display for a few seconds. • If you turn the power off the output is set to STEREO1, however, if you select MIX/VARI. again with the wireless controller, your previously mixed balance will appear. Additional Information 86