Canon EOS Rebel T5i Video Creator Kit Instruction Manual - Page 127

3 Noise Reduction SettingsN About [Multi Shot Noise Reduction] The following functions cannot be set: AEB, WB bracketing, [z3: Long exp. noise reduction], 1+73/1. If any of these has already been set, [Multi Shot Noise Reduction] cannot be set. Flash shooting is not possible. The AF-assist beam will be emitted according to the [54: Custom Functions (C.Fn)]'s [4: AF-assist beam firing] setting. You cannot set [Multi Shot Noise Reduction] for bulb exposures. If you turn off the power or change the shooting mode to a Basic Zone mode, movie shooting, or bulb, the setting will change to [Standard]. If there is significant misalignment in the image due to camera shake, the noise reduction effect may be minimal. If you are handholding the camera, keep it steady to prevent camera shake. Using a tripod is recommended. If you shoot a moving subject, the subject's movement may leave afterimages or the surrounding area of the subject may become dark. The image alignment may not function properly with repetitive patterns (lattice, stripes, etc.) or flat, single-tone images. Recording the image to the card will take longer than with normal shooting. During the processing of the images, "BUSY" will be displayed and you cannot take another picture until the processing is completed. [z3: Dust Delete Data] cannot be set. If [Multi Shot Noise Reduction] is set, direct printing (p.280) is not possible. Long Exposure Noise Reduction You can reduce noise in long exposures. 1 Select [Long exp. noise reduction]. Under the [z3] tab, select [Long exp. noise reduction], then press . 127