Canon EOS50D EOS 50D Instruction Manual - Page 201

Error Codes Error No. Countermeasures If there is a problem with the camera, an error message appears. Follow the onscreen instructions. To recover from the error screen, turn the power switch and , or remove and reinstall the battery. If error 02 (Card problem) is displayed, remove and reinstall the card or format the card. This may resolve the problem. If the same error keeps appearing, there may be a problem. Write down the error code and consult your nearest Canon Service Center. No. Err 01 Err 02 Err 04 Err 05 Err 06 Err 99 Error Message & Solution Communications between the camera and lens is faulty. Clean the lens contacts. Î Clean the electrical contacts on the camera and lens, use a Canon lens, or have the camera or lens checked or repaired. (p.13,16) There is a problem with the card. Replace the card. Î Remove and install the card again, replace the card, or format the card. (p.29, 43) Cannot save images because the card is full. Replace the card. Î Replace the card, erase unnecessary images, or format the card. (p.29, 144, 43) The built-in flash's auto pop-up was obstructed. Turn the power switch to and again. Î Operate the power switch. (p.27) Self Cleaning Sensor Unit malfunction. Consult with Canon Service Center. Î Operate the power switch or have the camera checked or repaired. (p.27) Shooting is not possible. Turn the power switch to and again or re-install the battery. Î Operate the power switch, remove and install the battery again, use a Canon lens, or have the camera checked or repaired. (p.27,26) 201