Canon I450 i450 Easy Setup Instructions - Page 1

1 Unpack the Printer 1 Carefully remove all items from the box. i450 Series Color Bubble Jet Printer 2 Prepare the Printer 1 Remove all shipping tape from the front and sides of the printer. Shipping Tape 2 Plug the power cord into the back of the printer and connect the other end to a power outlet. Start Here Easy Setup Instructions 3 Install the Print Head 4 Install the Ink Tanks 1 Remove the print head from its package. Tear at notch to open 2 Remove the orange protective cap. NOTE: Do not touch the electrical contacts on the back and bottom of the print head. Electrical contacts 1 Remove the black ink tank (BCI-24 Black) from its package and pull off the orange protective cap. NOTE: To avoid spilling ink, do not touch the bottom of the tank once you have removed the protective cap. Protective cap 2 Insert the black ink tank into the slot on the right, then push in until the ink tank locks into place. i450 Series Color Bubble Jet Printer 5 Connect the Printer To Your Computer 1 Turn the printer off. IMPORTANT: Be sure printer is off before continuing, or the computer will attempt to install the printer driver before the printer is ready. 2 Connect one end of a USB cable (not included) to the computer, the other to the printer. Paper Rest Documentation and Software Kit 3 Press the Power button. 3 Raise the gray lock lever on the printer. Power Button Power Lamp Click 4 Open the output tray, then open the front cover. The print head holder automatically moves to the center. 4 Slide the print head into the holder until it is securely seated. Do not press it down. 3 Repeat the procedure for the color ink tank (BCI-24 Color), inserting it into the remaining slot. USB Cable USB Port i450 Series Print Head Power Cord Ink Tanks BCI-24 Black BCI-24 Color Output Tray 5 Lower the lever until it locks into place. Serial number Write down the serial number located to the right of the print head. You will need this later to register the product. 4 Close the front cover, attach the paper rest and pull out the output tray. Continue with Step 6 on side two.