Canon I470D i470D Easy Setup Instructions - Page 1

1 Unpack the Printer 1 Carefully remove all items from the box. i470D Series Photo Printer 2 Prepare the Printer 1 Remove all shipping tape from the front and sides of the printer. Shipping Tape 2 Plug the power cord into the back of the printer and connect the other end to a power outlet. Start Here Easy Setup Instructions 3 Install the Print Head 4 Install the Ink Tanks 1 Remove the print head from its package. Tear at notch to open 2 Remove the orange protective cap. NOTE: Do not touch the electrical contacts on the back and bottom of the print head. Electrical contacts 1 Remove the black ink tank (BCI-24 Black) from its package and pull off the orange protective cap. NOTE: To avoid spilling ink, do not touch the bottom of the tank once you have removed the protective cap. Protective cap 2 Insert the black ink tank into the slot on the right, then push in until the ink tank locks into place. i470D Series Photo Printer 5 Connect the Printer To Your Computer 1 Turn the printer off. IMPORTANT: Be sure printer is off before continuing, or the computer will attempt to install the printer driver before the printer is ready. 2 Connect one end of a USB cable (not included) to the computer, the other to the printer. Paper Rest Documentation and Software Kit 3 Press the Power button. 3 Raise the gray lock lever on the printer. Power Button Power Lamp Click 4 Open the output tray, then open the front cover. The print head holder automatically moves to the center. 4 Slide the print head into the holder until it is securely seated. Do not press it down. 3 Repeat the procedure for the color ink tank (BCI-24 Color), inserting it into the remaining slot. USB Cable USB Port i470D Series Print Head Power Cord Ink Tanks BCI-24 Black BCI-24 Color Output Tray Serial number 5 Lower the lever until it locks into place. Write down the serial number located to the right of the print head. You will need this later to register the product. 4 Close the front cover, attach the paper rest and pull out the output tray. Continue with Step 6 on side two.