Canon LV-5100 Owners Manual - Page 13
Connecting To The Computer
View all Canon LV-5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
CONNECTING THE PROJECTOR CONNECTING TO THE COMPUTER Cables used for connection (✽ = Cables are not supplied with this projector.) • VGA CABLE (HDB 15 pin) • CONTROL CABLE FOR PS/2 PORT • CONTROL CABLE FOR SERIAL PORT, or ADB PORT ✽ • MAC ADAPTER (When connecting to Macintosh computer) ✽ • AUDIO CABLE (Mini Plug (stereo)) ✽ NOTE : When connecting the cable, the power cords of both the projector and the external equipment should be disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on. IBM-compatible computers or Macintosh computers (VGA / SVGA / XGA / SXGA) Desktop type Laptop type Monitor Output MAC Adapter ✽ Set the slide switches following the chart below. Serial port PS/2 port ADB port Audio Output Control Cable Control Cable Control Cable for Serial Port ✽ for PS/2 Port for ADB Port ✽ Terminal Terminal Terminal Audio Cable (stereo) ✽ VGA Cable Use one of these Control Cables corresponding with the terminal of your computer. Terminals of the Projector VIDEO S - VIDEO Y - Pb/Cb - Pr/Cr AUDIO OUT Audio Cable (stereo) ✽ COMPUTER IN RESET AUDIO OUT AV COMPUTER IN COMPUTER AUDIO IN CONTROL PORT COMPUTER AUDIO IN CONTROL PORT Audio Input Audio Amplifier Audio Speaker (stereo) x MAC ADAPTER (Not supplied) Set the switches as shown in the table below depending on the RESOLUTION MODE that you want to use before you turn-on the projector and computer. ON OFF ON DIP 123456 1 2 3 4 56 13" MODE (640 x 480) ON ON OFF OFF OFF OFF 16" MODE (832 x 624) OFF ON OFF ON OFF OFF 19" MODE (1024 x 768) OFF ON ON OFF OFF OFF 21" MODE (1152 x 870) ON ON ON ON OFF OFF 13