Canon LV-7370 Projector Monitoring Software Ver.1.0.0 User's Manual - Page 21
Setting the Protocol of a Projector
View all Canon LV-7370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
CHAPTER 2 • Routine Operation 222222 Setting the Protocol of a Projector Projectors in the Projector list will display as "Disconnected" if network settings of projectors are changed. In this case, adjust the protocol settings of the projector labelled "disconnected" in accordance with the changed network settings, with the following procedures. 11 Select [Protocol settings] from the [Projector] menu. "Protocol settings" dialog will appear. 22 Select a protocol from the [Protocol] pop-up menu, and adjust the settings. Category IP address Community name (SNMP V1/V2c/V3 only) Port number (LV Series only) Timeout Password (SNMP V3 only) Description Enter an IP address of the projector, in "XXX.XXX.XXX. XXX" form. Enter a community name within 15 one-byte alphanumerical characters and symbols. Enter a port number to be used, in one-byte numbers. Default value is set to "7142". Enter a number of seconds to time out, from 1 to 9. Enter a password within 8 to 15 one-byte alphanumeric characters and symbols. * Password is reset if protocol is changed. Note -- An error message will appear and settings will not be registered if a value of an entry is invalid or insufficient. Correct it as required. -- Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before clicking the [OK] button. -- Projectors may not connect immediately after its IP address is changed. Refresh the projector status after a while. 33 Click [OK] when you have finished adjusting the settings. Projector's protocol settings will be changed. 21