Canon MF8450C imageCLASS MF9170c/MF9150c/MF8450c Basic Operation Guide - Page 452
The memory is full., The original is too long., The scan area is dirty.
View all Canon MF8450C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 452 highlights
Error Messages Message The memory is full. The original is too long. The scan area is dirty. The TEL number is not registered. This size cannot be used with 2Sided unit modes. Wait a moment... Description Action - The machine is full of jobs. - Print, send, or delete any documents stored in memory. - Divide the document stack or data into a few parts and try again one by one. - Send the document with low resolution. - When this message appears during using the feeder, the scanning document stops halfway. In this case, clear the paper jam from the ADF. - The number of TX/RX jobs that can be stored in memory reached the maximum. - The maximum numbers of jobs that can be stored in memory are as follows (Based on the condition that the other party sends the fax by the Color imageCLASS MF9170c, MF9150c and MF8450c with ITU-T No. 1 Chart standard mode); Up to 70 jobs for sending or 90 jobs for receiving, 95 fax jobs including sending and receiving, or 75 e-mail and I-fax jobs for receiving. Wait for the machine to send any documents in memory. Also print, send, or delete any documents stored in memory. - The originals fed from the feeder - Reduce the length of the originals is longer than 24 7/8" (630 mm), or to within 24 7/8" (630 mm), then try are not feeding correctly. again. - The originals are longer than 14" (355.6 mm) when you are sending e-mail, I-fax or sending a document to a file server. - If the originals are shorter than 14" (355.6 mm), then try the procedure again. The feeder's scanning area is dirty. Clean the feeder's scanning area. No destination is registered for the One-touch you pressed. Register the destinations before using the Address Book function. The paper size is not appropriate for Set the paper size to or , a two-sided copy. then load paper of the same size. This message appears when turning Wait until the message disappears. ON the main power switch, or when the machine is not ready for printing. Troubleshooting 12-29