Canon MF8450C imageCLASS MF9170c/MF9150c/MF8450c Starter Guide - Page 13
Make sure the following screen is displayed on, the display, then press, to proceed to - ip address
View all Canon MF8450C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
2 Set Up the Machine 5 Make sure the following screen is displayed on the display, then press [OK] to proceed to the "Setup Guide." Check that all the packing materials are removed from the main unit and the cartridges. If not, refer to the instruction sheet "Unpacking the Machine" and remove them all. 4 Make sure the following screen is displayed on the display, then press [OK] to proceed to the "Setup Guide." Do not connect the USB cable at this point even if you use the machine as a local printer by directly connecting the machine to the computer. During the software installation procedure, you can connect the USB cable. (When using the network function, the USB cable is not required.) 6 Make sure the following screen is displayed on the display. The auto obtain IP address function will enables the machine to get the IP address after connecting the LAN cable to the machine. - If the LAN cable has not been connected yet, connect it as described in "Connect the LAN Cable," on p. 8. - Connect the LAN cable when you use the machine to share with a group through the network. - Connect the LAN cable even if you do not use the auto obtain IP address function, because your network environment requires the IP address to be set manually. Go to "Load Paper," on p. 12. If the toner cartridges have not been set in the machine or the tabs and tape have not been removed from the toner cartridges, the screen appears. You will need to finish the cartridge installation before you proceed. (See "Install Toner Cartridges," on p. 4.) 11