Canon PIXMA MP620B Network Setup Troubleshooting - Page 6

5.3 The Printer could not be connected to the specified access point is displayed during setup This message is displayed when the machine could not connect to the target access point. Clicking the OK displays the Access Points dialog box. For details, refer to "2.2 Cannot connect to the target access point" on page 1. 5.4 The Another access point with the same SSID exists is displayed during setup Cancel the current setup and change the SSID of the access point, then start the setup again. 5.5 The New port could not be created is displayed during setup Uninstall the MP Drivers, then setup the machine again following the procedures in "Install the Software" and onward in the printed manual: Getting Started. 5.6 The Set Printer IP Address dialog box is displayed during setup The following dialog box is displayed if no machine was detected on the network. Make sure of the following, and click the Connect. • The network devices are turned on, and the machine and the computer are connected to the net- work. • The machine and the computer are connected with the USB cable. • The IP address to be set for the machine is displayed on the Set Printer IP Address dialog box. If it is different from the address you want to set for the machine, select Use next IP address and enter the desired IP address. (If the machine is turned off, the Set Printer IP Address dialog box does not appear.) If it still fails, specify the IP address of the machine and click Connect to retry the detection of the machine. (A) (B) (C) (D) (E) (A) Get IP address automatically Select to use an IP address provided by a DHCP server. This requires that the DHCP function is enabled on the router or access point. (B) Use next IP address Select to manually specify an IP address, for example if there is no DHCP server functionality in the network environment in which you are using the machine. 5.6 The Set Printer IP Address dialog box is displayed during setup (continued) (C) IP Address/Subnet Mask/Default Gateway Enter each value to specify a fixed IP address when Use next IP Address is selected. (D) Network Information Displays the Network Information dialog box. Click this button to confirm network settings when your access point or your machine cannot be detected automatically during setup for use over the network. This button is enabled when an access point was not detected or could not be connected. (E) Connect Searches for the machine with the specified settings. If the machine is still not be detected with a specified IP address, refer to "4.1 The machine is not detected" on page 2. • Clicking the Back displays the Access Points dialog box. (A) (B) (C) (D) (A) TCP/IP Setting Select Get IP address automatically or Use following IP address. Select Get IP address automatically to use an IP address provided by a DHCP server. This requires that the DHCP function is enabled on the router. Select Use following IP address to manually specify an IP address, for example if there is no DHCP server functionality in the network environment in which you are using the machine. (B) IP Address/Subnet Mask/Router Enter each value to specify a fixed IP address when Use next IP address is selected. (C) Network Information Displays the Network Information dialog box. Click this button to confirm network settings when your access point or your machine cannot be detected automatically during setup for use over the network. This button is enabled when an access point was not detected or could not be connected. (D) Connect Searches for the machine with the specified settings. If the machine is still not be detected with a specified IP address, refer to "4.1 The machine is not detected" on page 2. • Clicking the Back displays the Access Points dialog box.