Canon PIXMA MX7600 Easy Setup Instructions for USB Connection and Software Ins - Page 2

2 Easy Setup Instructions for USB Connection and Software Installation Office All-In-One Important Before proceeding to USB connection and software installation, be sure to read your setup sheet for preparing the machine first and complete hardware setup and Print Head alignment. Note • Since Mac® OS 9, Mac OS X Classic environments, or Mac OS X v.10.3.8 or earlier are not supported, do not connect the machine to these. • The screens below refer to Mac OS X v.10.4.x installation. Screens may vary depending on the operating system you are using. • Log on as an Administrator. • Quit all running applications before installation. a Connect one end of the USB cable to the computer and the other to the machine. Note Make sure the machine is turned on. e When the main menu appears, click Easy Install. The MP Drivers, On-screen Manuals, and application software are installed automatically. • USB connection software installation are explained here. For wired LAN connection, refer to the Network Setup Guide. • A USB cable is necessary to connect the machine with your computer. i When the User Registration screen appears, click Next. Note To register later, click Cancel and go to Step j. After software installation is complete, double-click on the desktop. If your network is connected to the Internet, the registration screen will appear. Follow the on-screen instructions to register your product. You will need your product serial number, which is located on the inside of the machine. k When the Canon IJ Network Tool screen appears, select USB connection, then click OK. Note If you want to select particular items to install, click Custom Install and follow the onscreen instructions to proceed with the installation. f When the list of applications to install appears, confirm the contents, then click Install. j When the Installation completed successfully screen appears, click Restart. After the computer restarts, remove the Setup CD-ROM. Note When using Mac OS X v.10.3.9, before using the Operation Panel on the machine to save scanned originals to the computer, it is necessary to select MP Navigator EX as the launch application on Image Capture under Applications. For details, refer to "Scanning Images" in the User's Guide on-screen manual. USB b Turn on your Mac and insert the Setup CD-ROM. Note If the CD-ROM folder does not open automatically, double-click the CD-ROM icon on the desktop. c Double-click the Setup icon. Note Move the cursor over items to display explanations of each application. g Read the License Agreement carefully and click Yes. The software installation screen may appear during the installation process. Read the contents on the screen and follow the onscreen instructions to install the software. h When the Setup Complete screen appears, click Next. d When the Authenticate screen appears, enter your administrator name and password. Click OK. Software installation is now complete. When the computer restarts, the Canon IJ Network Tool will start up automatically. Note Keep the CD-ROM in a safe place in case you need to reinstall the software. When using Mac OS X v.10.3.9: Restarting the computer while connected to the machine may cause the machine not to be detected. To resolve this, either unplug the USB cable then plug it back in again, or turn the machine off then back on again. Note XXX FAX (where "XXX" is your machine's name) is shown in the Printer Name list (Product list in Mac OS X v.10.3.9), but you cannot add XXX FAX. You cannot send faxes from your computer via the machine. If you do not know your administrator name or password, click , then follow the on-screen instructions. Part no. QT5-0073-V01 © 2008 Canon Inc. "Macintosh" and "Mac" are trademarks of Apple Inc., registered in the U.S. and other countries. XXXXXXXX Printed in THAILAND