Canon PIXMA MX7600 Easy Setup Instructions for Preparing the Machine - Page 2

3 Install the Ink Tanks Note For the ink tanks compatible with this machine, refer to the back cover of the Quick Start Guide. a Remove and discard the orange protective cap located on the bottom of the ink tank. Protective Cap Ink Port 4 Install the Clear Ink Tank a Remove the orange tape in the direction of the arrow to peel off the protective film from the clear ink tank. Do not touch! Do not press! Electrical Contacts Important • Do not touch the electrical contacts. • Do not touch the ink port. b Insert the ink tank into the right-hand slot and press the mark on the ink tank until it clicks into place. b Push the tab and open the Clear Ink Tank Locking Cover. c Be sure that the clear ink tank is properly aligned when inserting. 5 Align the Print Head a Close the Paper Output Tray and pull out the Cassette from the machine. b Load four sheets of plain paper in the Cassette with the printing side facing DOWN and the leading edge to the far side, align the paper stack against the right side of the Cassette, then slide the Paper Guides to fit to the loaded paper stack. Paper Guide c Insert the Cassette into the machine. Push the Cassette all the way into the machine. For fax users To use a fax, you need to set the telephone line type setting properly on the machine. If you are unsure of your telephone line type, contact your telephone company. Select the receive mode according to your needs. • When you receive mainly faxes and sometimes voice calls: → FAX priority mode • When you have a dedicated telephone line for fax use only: → FAX only mode • When you receive mainly voice calls and sometimes faxes: → TEL priority mode • When you subscribe to a ring pattern detection service provided by your telephone company, and you want to receive a fax only if the machine detects the pattern for fax: → DRPD For details on how to confirm and change the settings, refer to the Quick Start Guide. c Make sure the ink lamp lights red. Refer to the color guide on the Print Head Lock Lever. d Close and press the round, indented portion on the Clear Ink Tank Locking Cover until it snaps firmly into place, locking the ink tank. d Make sure that Yes is selected in the message requesting head alignment, then press the OK button. For USB connection and software installation, proceed to "2 Easy Setup Instructions for USB Connection and Software Installation." For wired LAN connection, refer to the Network Setup Guide. e Close the Scanning Unit (Printer Cover). Note Print Head alignment takes about 9 minutes to complete. Do not start another operation until the machine has stopped making operating noises. The pattern is printed. And Print Head is aligned automatically. OK Part no. QT5-0072-V02 © 2008 Canon Inc. Caution For your safety, always firmly grip the areas illustrated when closing the Scanning Unit (Printer Cover). Important The machine starts the preparatory operation. It takes about 2 minutes. Do not start another operation until the machine has stopped making operating noises. Note If the Alarm lamp lights and an error message is displayed on the LCD, refer to "An Error Message Is Displayed on the LCD" in the Quick Start Guide. Note • The pattern is printed in black and blue. • When Automatic Print Head Alignment cannot be executed correctly, the message "Auto head align has failed." is displayed on the LCD. Refer to "An Error Message Is Displayed on the LCD" in the Quick Start Guide. Hardware setup and Print Head alignment are complete. XXXXXXXX Printed in THAILAND