Canon PIXMA PRO-1 Network Setup Troubleshooting - Page 3

Problems during Software Installation The Printer is Not Displayed (Detected) Check B B Check 4 Is the printer connected to a network? • To check if the printer is connected to a network, print the Network Configuration Page, then make sure that Link Status is set to Active. To print the Network Configuration Page, hold down the RESUME/CANCEL button (C) on the printer until the POWER lamp (D) flashes 6 times, then release the RESUME/CANCEL button after the sixth flash. C D A A Check 1 Make sure that you follow "Connection Checklist" on page 7, then click Redetect (A). Check 2 Turn off the network device (router, etc.), turn it back on, then click Redetect (A). Check 3 Make sure that the DHCP function of the network device (router, etc.) is active. • To specify the IP address, set up a wired connection using a USB cable. Click Set Up New Printer (B), then go to in "Specifying the Printer's IP Address" on page 5. • For details on how to check settings of the network device, refer to the manual supplied with the network device or contact its manufacturer. If the printer is not connected to a network, perform setup again by following the procedures from "Set Up a Wired Connection" in the printed manual: Getting Started. Check 5 If the printer is not detected, set up a wired connection using a USB cable. Click Set Up New Printer (B), then perform the following procedure. E Activate the DHCP function of the network device, then click Redetect (A). • For details on how to change settings of the network device, refer to the manual supplied with the network device or contact its manufacturer.  E 1 Click Next (E) on the Set Up New Printer screen. 2 When the Connect Cable screen appears, connect the printer to the computer with a USB cable. For Macintosh, click Next. • When the Set Printer IP Address screen appears, check the IP address settings by referring to Check 4 and onward in "Set Printer IP Address Screen is Displayed" on page 4.