Canon PIXMA iP4000 iP4000 Easy Setup Instructions - Page 1

1 Unpack the Printer 2 Prepare the Printer Start Here Easy Setup Instructions 3 Install the Print Head 4 Install the Ink Tanks iP4000 Series Photo Printer 5 Connect the Printer and Load Paper 1 Carefully remove all items from the box. PIXMA iP4000 Series Photo Printer 1 Remove all shipping tape and clear plastic from the printer. 2 Plug the power cord into the back of the printer and connect the other end to a power outlet. Press the POWER button. The printer will initialize. 1 Remove the print head from its package. Tear at notch to open 2 Remove the orange protective cap from the print head. NOTE: Do not touch the print head nozzles and the electrical contacts. 1 Peel back the orange tab and completely remove the plastic wrapper from the Cyan Ink Tank (BCI-6C). 2 Twist off and discard the orange protective cap. NOTE: To avoid spilling ink, never press on the sides of an ink tank. Protective cap IMPORTANT: Be sure the printer is off before continuing, or the computer will attempt to install the printer driver before the printer is ready. For USB Port: 1 TURN THE PRINTER OFF. 2 Connect one end of the USB cable to the computer, the other to the printer. 3 Insert the ink tank into the correct slot. (Refer to the color guide on the print head holder). Press down until the ink tank clicks into place. USB Cable USB Port Documentation and Software Kit PIXMA iP4000 Series Print Head Power Cord 3 Lower the front cover. Raise the top cover. Remove the shipping tape and lower the inner cover. Top Cover Inner Cover Print Head Nozzles Electrical Contacts 3 Raise the print head lock lever. Front Cover 44 The print head holder automatically moves to the center. Remove the protective tape. 4 Slide the print head into the holder. The print head will rest at a slight angle. Ink Tanks BCI-6BK Black BCI-6Y Yellow BCI-3eBK Black BCI-6M Magenta BCI-6C Cyan 5 Write down the serial number located to the right of the print head holder. You will need this later to register the product. Serial Number Location 5 Lower the print head lock lever and press it down until it clicks into place. click click 4 Insert the remaining four ink tanks into their assigned slots. USB Port USB Cable For Parallel Port: 1 TURN THE PRINTER OFF. 2 Connect one end of the parallel cable to the computer, the other to the printer. 5 Close the inner cover, then the top cover. Lift open the paper support and extend the paper output tray. Top Cover Paper Support Inner Cover Paper Output Tray NOTE: The printer will perform a print head cleaning. Wait until the POWER lamp displays a steady green light before proceeding. Parallel Cable 3 Remove the shipping tape from the paper guide. Pinch the paper guide and slide it to the left. Load a few sheets of blank paper into the auto sheet feeder, then slide the paper guide toward the left edge of the paper. Auto Sheet Feeder Paper Guide Continue with Step 6 on side two.