Canon VB-M641VE Network Camera VB-R11VE/VB-R11/VB-R10VE/VB-M641VE/VB-M641V/VB- - Page 152
Exiting Viewer PTZ, The Viewer PTZ panel appears.
View all Canon VB-M641VE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
1 Click the [Viewer PTZ] button. The Viewer PTZ panel appears. Initially, the preview frame (orange) surrounds the entire video. 2 In the Viewer PTZ panel, drag an edge of the preview frame to make it smaller. The video of the area inside the preview frame is magnified to fill the video display area. Preview Frame 3 Move the frame to the area you would like to magnify and resize the frame as desired. Move or Resize by Dragging Press the mouse button inside the frame and drag it to move the preview frame. If you press the mouse button and drag outside the frame, a new preview frame will be drawn. You can resize the preview frame by dragging an edge of the frame. Move by Clicking If you click outside the frame, the preview frame will move and center on that point. Move Using the Sliders M641 M640 M741 M740 You can use the pan, tilt and zoom sliders in the video display area to move the preview frame. Note The Viewer PTZ uses digital zoom, so the higher the digital zoom ratio, the lower the quality of the video. Exiting Viewer PTZ When you click the [Viewer PTZ] button while using the Viewer PTZ, the Viewer PTZ panel closes and you exit the Viewer PTZ. Note • If you close the Viewer PTZ panel without exiting the Viewer PTZ, the view in the video display area will remain magnified. However, when you reconnect to the Admin Viewer, the initial state will be restored. 152