Canon i560 Series i560 Easy Setup Instructions - Page 1

1 Unpack the Printer 1 Carefully remove all items from the box. i 560 Series Desktop Photo Printer 2 Prepare the Printer 1 Remove the shipping tape from the front and back of the printer. Shipping Tape 2 Plug the power cord into the back of the printer and connect the other end to a power outlet. Start Here Easy Setup Instructions 3 Install the Print Head 1 Remove the print head from its package. Tear at notch to open 2 Remove the orange protective cap from the print head nozzles. NOTE: Do not touch the print head nozzles or electrical contacts. 4 Install the Ink Tanks 1 Peel back the orange tab and completely remove the plastic wrapper from the Yellow Ink Tank (BCI-6Y). 2 Twist off and discard the orange protective cap. NOTE: Avoid ink at the bottom of the tank. Protective Cap i560 Series Desktop Photo Printer 5 Connect the Printer and Load Paper IMPORTANT: Be sure the printer is off before continuing, or the computer will attempt to install the printer driver before the printer is ready. For USB Port: 1 TURN THE PRINTER OFF. 2 Connect one end of the USB cable to the computer, the other to the printer. Documentation and Software Kit i 560 Series Print Head Power Cord 3 Press the POWER button. POWER Button POWER Lamp Print Head Nozzles Electrical Contacts 3 Raise the lock lever on the printer. 4 Open the front cover. The print head holder automatically moves to the center. Remove the protective tape. 4 Slide the print head into the holder. The print head will rest at a slight angle. Ink Tanks BCI-6C Cyan BCI-6M Magenta BCI-3eBK Black BCI-6Y Yellow Protective Tape 5 Lower the lock lever and press it down until it clicks into place. Serial Number 5 Write down the serial number located to the right of the print head holder. You will need this later to register the product. click 3 Insert the ink tank into the correct slot. (Refer to the color guide on the print head holder). Press down until the ink tank clicks into place. IMPORTANT: For correct printer operation, make sure the ink tanks are secure in slots. click USB Cable USB Port For Parallel Port: 1 TURN THE PRINTER OFF. 2 Connect one end of the parallel cable to the computer, the other to the printer. 4 Insert the remaining ink tanks into their assigned slots. 5 Close the front cover and extend the paper rest and paper output tray. Paper Rest Parallel Cable Secure Wire Clips Parallel Port 3 Pinch the paper guide and slide it to the left. Load a sheet of blank paper in the paper rest. Slide the guide toward the left edge of the paper. Output Tray NOTE: The printer will perform a print head cleaning once the cover is closed. Continue with Step 6 on side two. Paper Guide