Canon imagePROGRAF PRO-4000 imagePROGRAF PRO-6000 / PRO-6000S / PRO-4000 / PRO - Page 10
Perform Print Head Adjustment and Select the Connection Method (on the PRO-2000), USB connection
View all Canon imagePROGRAF PRO-4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Perform Print Head Adjustment and Select the Connection Method (on the PRO-2000) 1 The paper starts feeding, and then the printer automatically starts charging the system with ink and adjusting the print head. Charging the system with ink and adjusting the print head for the first time takes about 45 minutes. • Do not open the covers of the printer Important or turn the power off while the ink is charging for the first time and the print head adjustment is executing. • Charging the system with ink fills the Note system from the ink tanks to the print head. In addition, cleaning is performed to keep the printer in optimal condition. This may cause the remaining ink indicator and maintenance cartridge capacity indicator to drop some amount. The starter ink tank is for first-time installation. It is recommended that you purchase replacement ink tanks quickly. 2 Once a single sheet of the adjustment pattern has finished printing, lift up the release lever and remove the paper for adjustment. 3 Check the screen. When a screen for selecting the connection method is displayed Proceed directly to step 4. When a screen prompting you to add paper is displayed Load the second sheet of paper by referring to steps 2 to 5 on p.9. 4 Once the print head adjustment has finished, the screen below appears. Tap the connection method to use. Check the message about the connection method and tap Yes if there are no problems. 5 If you selected USB connection Proceed to "Connect to the Printer" on p.12. USB connection This is the method for connecting the printer to a computer using a USB cable. Only 1 printer can be connected. Do not connect the USB cable yet. Wired LAN connection This is the method for connecting the printer to the network using a LAN cable. Wireless LAN connection This is the method for connecting the printer to the network without using a cable. If you selected Wired LAN connection Use the LAN cable to connect the wired LAN connector on the back of the printer to the hub port. Tap OK, and then proceed to "Connect to the Printer" on p.12. If you selected Wireless LAN connection To configure the wireless LAN settings using a computer, tap Yes, or to configure the wireless LAN settings on the printer, tap No, and proceed to "Connect to the Printer" on p.12. If you selected Do not connect Setup has finished at this point. However, the connection settings and software installation will need to be performed separately in order to use the printer from a computer. (Refer to "Connect to the Printer" on p.12) To load roll paper after setup, tap the paper settings display area from the home screen, then (roll paper icon), then Replace paper, and follow the instructions on the screen. For details, refer to the Online Manual that can be accessed by the procedure in "How to Display the Online Manuals" (p.14). 10