Canon imagePROGRAF iPF650 iPF650 User Manual Ver.1.30 - Page 814

Error Message > Messages regarding paper > Cause When Detect Mismatch in the Control Panel menu is set to Pause or Warning, the width of the loaded roll does not match the width specified in Fit Roll Paper Width in the printer driver. Corrective Action Make sure the roll width selected in the dialog box displayed when you select Fit Roll Paper Width in the printer driver matches the width of the roll loaded in the printer, and then try printing again. Paper size not detected. Cause Paper has been loaded askew, or warped paper has been loaded. Corrective Action Follow these steps to reload the roll. 1. Push the Release Lever back. 2. Adjust the right edge of the roll to make it parallel to the orange Paper Alignment Line. 3. Pull the Release Lever forward. 4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK button. Printing will resume, starting from the page on which the error occurred. (See "Loading Rolls in the Printer.") →P.572 If this error recurs after you reload the roll, remove the Roll Holder from the printer, push the roll firmly in until it touches the Roll Holder flange, and reload the Roll Holder in the printer. (See "Attaching the Roll Holder to Rolls.") →P.568 Follow these step to reload a sheet. 12 1. Push the Release Lever back. 2. Load the sheet, aligning it with the guide on the right. 3. Pull the Release Lever forward. 4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK button. Printing will resume, starting from the page on which the error occurred. 798 (See "Loading Sheets in the Printer.") →P.594 Because the Platen is soiled with ink or other substances, the size of the clear film cannot be detected. Open the Top Cover and clean the entire Platen. (See "Cleaning Inside the Top Cover.") →P.744 Paper size not detected. iPF650