Canon imagePROGRAF iPF8400 Setup Guide - Page 5

Install the Printheads Install both printheads. 1 When the display screen shows Open top cover., open the top cover. 2 Lift the carriage cover to open it fully. 3 Pull the printhead fixer lever forward all the way to open it completely. Instructions on printhead installation are shown on the display screen. 4 Lift the printhead fixer cover to open it fully. 5 Hold the printhead by the grips (a) as you remove it from the pouch. 6 Remove the orange protective part (a). Remove the other orange protective part (b) while holding the grip (c). bc a a a . • Never touch the parts covered by the protective parts. Doing so may damage the printhead and affect printing quality. • The printhead contains ink, so be careful not to spill it once the protective parts are removed. • Do not reattach the protective parts after removing them. Dispose of these materials according to local regulations. 7 Insert the printhead into the carriage (b) with the ink holes (a) up and facing the front of the printer as shown in the figure. Carefully push the printhead firmly into the carriage (b), ensuring that the parts that were covered by the protective parts do not touch the carriage (b). a 8 Pull the printhead fixer cover down toward the front to lock the printhead in place. 9 Push the printhead fixer lever all the way back. b 10 Repeat steps 3 to 9 to install the second printhead set. 11 Pull the carriage cover forward. 12 Close the top cover. 5