Canon imageRUNNER 1435P Startedr Guide - Page 5

Choosing the Method to Connect the Machine to the Computer ●● Connecting via a LAN You can connect the machine to the computer through a wired LAN router. Use a LAN cable to connect the machine to the router. Setting Up the LAN Connection 1 Connect the LAN cable. Make sure that there are ports available on the router to connect the machine and the computer. Have a Category 5 or higher twisted pair LAN cable ready. ●● Connecting via a USB cable You can connect the machine to the computer using a USB cable. Make sure that the USB cable you use has the following mark. Connecting via a LAN Checking Before the Setup Internet Router LAN cable Are the computer and the router properly connected using a LAN cable? For more information, see the instruction manual for the network device you are using, or contact the networking device manufacturer. Have the network settings on the computer been completed? If the computer is not properly configured, you may not use the wired LAN connection even after completing the following settings. NOTE • When you connect to a network environment that is not security protected, your personal information could be disclosed to third parties. Please use caution. • If you connect through a LAN in the office, contact your network administrator. The IP address will be automatically configured in 2 minutes. If you want to set the IP address manually, see the following items. e-Manual "Network" ▶ "Connecting to a Network" ▶ "Setting IP Addresses" 2 Download the appropriate drivers from the Canon website (http://www.canon.com/). 3 Install the drivers on your computer. For details on the installation procedures, see the driver installation manuals that are included with the drivers. Proceed to "Setting a Paper Size and Type" (P.6). Connecting via a USB Cable Connect the USB cable after installing the drivers. 1 Download the appropriate drivers from the Canon website (http://www.canon.com/). 2 Install the drivers on your computer. For details on the installation procedures, see the driver installation manuals that are included with the drivers. 3 Connect the USB cable. Proceed to "Setting a Paper Size and Type" (P.6). 5