Carson TD-842 User Manual - Page 2

WATERPROOFING: All Carson 3D binoculars are nitrogen purged and o-ring sealed to protect your binocular from water damage. They are designed to protect against accidental splashing, rain or even full submersion in up to 1 meter of water for up to 5 minutes. OPTICAL COATINGS: All 3D binoculars featuer fully multi-coated optics, meaning that all glass surfaces have multiple coatings applied to them to prevent internal reflection and light loss. This results in images that are brighter, shaper and higher in contrast. As light travels through a roof prism binocular, it becomes slightly out of phase. This affects the color balance and fidelity. Your 3D binoculars are phase coated to correct this problem, forcing the light back into phase and therefore resulting in more accurate color reproduction. All 3D binoculars come with both a neck strap and a shoulder harness. You can choose either accessory to hold your binocular depending on your personal preference. ATTACHING THE NECK STRAP: ATTACHING THE SHOULDER HARNESS: 1. Thread the end of the strap up through the strap clip on the side of your binocular. 2. Thread the strap through the first loop of the plastic strap piece. 3. Continue to thread the strap through the second loop of the plastic strap piece. 4. Adjust the strap to the desired length and pull tight. 5. Slide the plastic cuff over the loose end of the neck strap. 1. Remove the security buttons from the quick release hooks on your binocular harness. 2. Slide the security button loop upward through the strap clips on each side of your binocular. 3. Feed the security button through the loop and tighten. 4. Attach quick release hook onto loop. 5. Slide security button into center of quick release hook. 2 1 2 3 4 5 USE OF A TRIPOD ADAPTER: All Carson 3D binoculars are compatible with most standard binocular tripod adapters. To attach a tripod adapter to your binoculars: 1. Twist the tripod adapter cap (located at the hinge in between the binocular barrels) counterclockwise and remove it. 2. Attach the binocular tripod adapter into the threaded hole in the binocular turning it clockwise until tight. 3. Attach the bottom of the tripod adapter to your tripod. NOTE: Tripod and adapter are not included with your 3D binoculars 1 2 3 INSTRUCTIONS FOR CARE: Cleaning must be done safely to avoid scratching the lenses. This can be accomplished with the following procedure: 1. Blow away any dust or debris on the lens (or use a soft brush.) 2. To remove dirt, grease or fingerprints, clean with a soft cotton cloth, rubbing in a circular motion. Use of a coarse cloth or unnecessary rubbing may scratch the lens surface and eventually cause permanent damage. 3. For a more thorough cleaning, use a Carson C6® lens cleaning product. 4. IMPORTANT: Never attempt to clean your binoculars internally or try to take them apart. 5. Keep binoculars in case when not in use. Customer Service: If you experience any difficulties, please contact us and we will be happy to help you. In the U.S.A. Phone: 1-631-963-5000 Email: [email protected] In the U.K. Phone: +44 (0) 1938 557440 Email: [email protected] In the E.U. Phone: +44 (0) 1938 557440 Email: [email protected] For warranty information, visit www.carson.com/warranty