Carvin TRx2115A TRx2000Aseries manual - Page 4
Caution
View all Carvin TRx2115A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
SPECIFICATIONS TRx2115A System Type: Active 2000W 15-inch 2-Way Frequency Response: 54 Hz - 20 kHz (-10dB) 62 Hz - 18 kHz (-3dB) Coverage Pattern: 80H x 50V Crossover: Bi-Amp Active DSP Crossover Frequency: 1.5 kHz Power total: 3000W two cycle pulse peak 2000W 20ms burst (1500W, 500W) 1500W RMS (1150W, 350W) Input Sensitivity: 1.4Vrms to full power Maximum Input signal: +12dBu Maximum SPL: 134dB Peak LF Driver: 15-inch cast frame, 3-inch Voice Coil HF Driver: 1.4-inch exit, 2.5-inch diaphragm Enclosure: 13-Ply Premium Russian Baltic Birch Suspension/Mounting: 1-3/8-inch pole mount cup 8 captive 3/8in -16 nut fly points Finish: Black Duratec™ Transport: 2 Recessed Handles Grill: Black powder coated steel Acoustically Transparent Foam Backing Connectors: XLR female (Input) XLR male (Thru) Terminal block (remote volume/mute) Locking IEC receptacles (AC IN / OUT) AC Power Requirements: 120VAC ("-E" 230VAC) 50-60Hz 600VA Dimensions (H x W x D): 25.75 in x 18.5 in x 14.5 in 654 mm x 470 mm x 368 mm Net Wt: 56 lb (25.5 kg) Rigging Accessories: TCSHK10 3/8-16 Eyebolt TCSHK58 5/8 S TRx2215A System Type: Active 2500W Dual 15-inch 3-Way Frequency Response: 50 Hz - 20 kHz (-10dB) 58 Hz - 18 kHz (-3dB) Coverage Pattern: 80H x 50V Crossover: Tri-Amp Active DSP design Crossover Frequency: 1.1 kHz Power: 3200W two cycle pulse peak 2500W 20ms burst (1000W, 1000W, 500W) 1600W RMS (625W, 625W, 350W) Input Sensitivity: 1.4Vrms to full power Maximum Input signal: +12dBu Maximum SPL: 135dB Peak LF Driver: two 15-inch cast frame, 3-inch VC HF Driver: 1.4-inch exit, 2.5-inch VC Enclosure: 13-Ply Premium Russian Baltic Birch Suspension/Mounting: 12 captive 3/8in -16 nut fly points Finish: Black Duratec™ Transport: 2 Recessed Handles Grill: Black powder coated steel Acoustically Transparent Foam Backing Connectors: XLR female (Input) XLR male (Thru) Terminal block (remote volume/mute) Locking IEC receptacles (AC IN / OUT) AC Power Requirements: 120VAC ("-E" 230VAC) 50-60Hz 600VA Dimensions (H x W x D): 41.5 in x 19 in x 20.5 in 1054 mm x 482 mm x 521 mm Net Wt: 92.4 lb (42 kg) Rigging Accessories: TCSHK10 3/8-16 Eyebolt TCSHK58 5/8 Shackle TRx2153A System Type: Active 2500W 15 Inch 3-Way Frequency Response: 50 Hz - 20 kHz (-10dB) 60 Hz - 18 kHz (-3dB) Coverage Pattern: 80H x 50V Crossover: Tri-Amp Active DSP Crossover Frequency: 500Hz, 1.1 kHz Power: 3500W two cycle pulse peak 2500W 20ms burst (1500W, 500W, 500W) 1850W RMS (1150W, 350W, 350W) Input Sensitivity: 1.4Vrms to full power Maximum Input signal: +12dBu Maximum SPL: 134dB Peak LF Driver: 15-inch cast frame, 3-inch VC MF Driver: 8-inch, 2-inch VC HF Driver: 1.4-inch exit, 2.5-inch VC Enclosure: 13-Ply Premium Russian Baltic Birch Suspension/Mounting: 12 captive 3/8in -16 nut fly points Finish: Black Duratec™ Transport: 4 Recessed Handles Grill: Black powder coated steel Acoustically Transparent Foam Backing Connectors: XLR female (Input) XLR male (Thru) Terminal block (remote volume/mute) Locking IEC receptacles (AC IN / OUT) AC Power Requirements: 120VAC ("-E" 230VAC) 50-60Hz 600VA Dimensions (H x W x D): 41.5 in x 19 in x 17 in 1054 mm x 482 mm x 432 mm Net Wt: 82.6 lb (37.5 kg) Rigging Accessories: TCSHK10 3/8-16 Eyebolt TCSHK58 5/8 Shackle CAUTION tttoohapcteormnsosatnyitsu.btTtp"teeodhrhaeeoainassfglRperesiesnrsruroykIctofmdSfeuiotucbshfKciooeevtefln'osluetuliOtsscanmeDtegirniFnarineccsOg"tltuenosoEwnlihsatiduNtoutLthheedcrinededekEOCTRTISORKPOIDCFEOERNNLSOEISCHTTOKROPICECONSDKHFOOCEKNLEOTttia(amoosCncThepcatdisrhoolTveemmsrOicrtyRatapipnmntirPanhegtIbntes)eoCoyEeinpunlinnaesisNscgenrtSerairctuntheoicHtneeftginoaOdnpespdCliinanKthcee.literature IMPORTANT! FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING: WATER AND MOISTURE: Appliance should not be used near water (near a bathtub, washbowl, sink, laundry tub, in a wet basement, near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. POWER SOURCES: The product should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization is not defeated. POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs. SERVICING: The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. FUSING: If your unit is equipped with a fuse receptacle, replace only with the same type fuse. Refer to replacement text on the unit for correct fuse type. SAFETY INSTRUCTIONS (EUROPEAN) The conductors in the AC power cord are colored in accordance with the following code. GREEN & YELLOW-Earth BLUE-Neutral BROWN-Live U.K. MAIN PLUG WARNING: A molded main plug that has been cut off from the cord is unsafe. NEVER UNDER ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT MAIN PLUG INTO A POWER SOCKET. LIMITED WARRANTY Your Carvin Audio loudspeaker is guaranteed against failure for 5 YEARS unless otherwise stated. Carvin Audio will service and supply all parts at no charge to the customer providing the unit is under warranty. Shipping costs are the responsibility of the customer. CARVIN AUDIO DOES NOT PAY FOR PARTS OR SERVICING OTHER THAN OUR OWN. A COPY OF THE ORIGINAL INVOICE IS REQUIRED TO VERIFY YOUR WARRANTY. Carvin Audio assumes no responsibility for horn drivers or speakers damaged by this unit. This warranty does not cover, and no liability is assumed, for damage due to: natural disasters, accidents, abuse, loss of parts, lack of reasonable care, incorrect use, or failure to follow instructions. This warranty is in lieu of all other warranties, expressed or implied. No representative or person is authorized to represent or assume for Carvin any liability in connection with the sale or servicing of Carvin Audio products. CARVIN AUDIO SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. MAINTAINING YOUR EQUIPMENT Avoid spilling liquids or allowing any other foreign matter inside the unit. The panel of your unit can be wiped with a dry or slightly damp cloth in order to remove dust and bring back the new look. As with all pro gear, avoid prolonged use in caustic environments (salt air). When used in such an environment, be sure the amplifier is adequately protected. SERVICE: In the USA, please go to www.carvinaudio.com under "SUPPORT" click on "REPAIR INFORMATION" Outside the USA: contact your dealer or go to http://www.carvinaudio.com click on "DEALERS" for your nearest service center. Include a written description of the problem with serial number and date of purchase. 76-08140D 040715 CAUTION REFER SERVICING TO QUALIFIED SERVICE PERSONNEL! THIS UNIT CONTAINS HIGH RISK OF ELECTRIC SHOCK VOLTAGE INSIDE!