Carvin TRx2115A TRx2115A data sheet - Page 2

Block Diagram and DSP Signal Flow INPUT THRU INPUT BUFFER REMOTE LEVEL/MUTE CONTROL INPUT LEVEL INPUT SENSITIVITY SETTING PARAMETRIC EQ REMOTE LEVEL/MUTE CONTROL PARAMETRIC LOW AND HIGH OUTPUT LEVEL EQ PASS FILTERS SPEAKER GUARD LIMITER ALIGNMENT DELAY POLARITY DYNAMIC BASS ENHANCEMENT PARAMETRIC LOW AND HIGH OUTPUT LEVEL EQ PASS FILTERS SPEAKER GUARD LIMITER ALIGNMENT DELAY POLARITY X-DRIVE DSP PROCESSING POWER AMP + - + POWER AMP + BRIDGE - CIRCUIT POWER AMP - HORN DRIVER LOW DRIVER Frequency Response at 1Watt / 1 Meter dBSPL 110 MONITOR 100 90 80 TRx2115 A 2000W BI-AMP SYSTEM MADE IN THE USA 70 20 Hz 50 100 200 500 1K 2K 5K 10K 20K 40K Rear Control Panel The 2000W TRx2115A active module features Input and Thru balanced XLR connectors, Input volume level, terminal block Remote Level/Mute Control, and Input and Thru locking IEC AC power connectors. The EQ MODE switch selects NORMAL, ENHANCED, or MONITOR modes. NORMAL EQ mode is a flat setting best for straight live sound. ENHANCED EQ mode is a club or dance playback setting with a minor mid cut and minor bass bump over the flat setting. MONITOR EQ Mode is designed for stage monitoring or when coupling two cabinets together to keep the bass frequencies and microphones under control. Use MONITOR mode when using the TRx2115A as a floor monitor, for side fills, or in very small venues. The BASS switch selects the bass mode with NORMAL, DYNAMIC EXTENSION, or EXTERNAL SUB. The Bass NORMAL mode does not change the bass setting. The DYNAMIC EXTENSION Bass mode extends the low frequency response another 15Hz with a boost in the 35-50Hz range. The EXTERNAL SUB Bass mode rolls off the cabinet at 85Hz, so an external subwoofer can be used. Dimensions 470mm [18,50in] 370mm [14,50in] 655mm [25,75in] 415mm [16,35in] 12340 WORLD TRADE DRIVE SAN DIEGO, CA USA 92128 CARVINAUDIO.COM Made in the USA