Casio E-200 User Guide - Page 62

• For international calls, allow more time for the call to go through. Tap and then Settings. On the Connections tab, tap Connections. Under The Internet settings or Work settings, select your setting and tap Modify. Tap your connection and tap Next twice. Clear Cancel the call if not connected within or increase the number of seconds allowed. Can dial out but can't make a proper connection • Make sure the network to which you are trying to connect supports the Point-to-Point Protocol (PPP). Your Internet service provider or network administrator can verify this. • Verify that the location is correct. Tap and then Settings. On the Connections tab, tap Connections. On the Dialing Locations tab, make sure that Location reflects your current location. Tap Dialing Patterns to make sure the correct sequence of numbers is being dialed. For information on dialing patterns, see Connections Help on the Pocket PC. • Verify that you are using the right phone number for the modem you are trying to reach Tap and then Settings. On the Connections tab, tap Connections. Under The Internet settings or Work settings, select your setting and tap Modify. Tap your connection and then Next and double-check the phone number you are trying to reach. Connection is unreliable • Make sure the modem is firmly seated and connected to your Pocket PC and the telephone jack. • Disable call waiting. Tap and then Settings. On the Connections tab, tap Connections. On the Dialing Locations tab, select Disable call waiting. Then enter the disable code specified by your telephone company. Network connection problems The following solutions may help if you encounter problems when using a network card for network connections. Additional troubleshooting information is available in Connections Help on the Pocket PC and ActiveSync Help on the desktop computer. • Verify that you have an Ethernet card that is compatible with your Pocket PC. • Verify that you have added necessary server information. Tap and then Settings. On the Connections tab, tap Network Adapters. Tap your installed adapter (usually your Ethernet card's name), tap Properties, and enter any necessary information. Most networks use DHCP, so you should not have to change these settings unless your network administrator instructs you to do so. • If Network Connection isn't listed as a connection method in the ActiveSync dialog box when starting synchronization, wait a few minutes and try again. Also, if synchronization does not start right away, the network is probably busy, and it may take a minute for your Pocket PC to connect to the network. • Make sure that the proper drivers for your card are installed on the Pocket PC. For more information, see the owner's manual for the network card. • Verify with your network administrator that your user name and password are correct. • Verify with your network administrator that the network you are trying to connect to is available, or try to connect to it from another computer. • You may need to change the Pocket PC name if you are trying to connect to a network and cannot because another Pocket PC with the same name is already connected. To change the Pocket PC name, tap and then Settings. On the System tab, tap About, and then the Pocket Device ID tab. 62