Casio EX-Z650 Owners Manual - Page 171

Problem Possible Cause and Recommended Action Images cannot be transferred over a USB connection. 1)The USB cable may not be connected securely. Check all connections. 2)The wrong USB communication protocol is selected. Select the correct USB communication protocol in accordance with the type of device you are connecting (pages 121, 130). 3)If the camera is not turned on, turn it on. 4)Your computer may not be able to recognize the camera if you connect via a USB hub. Always connect directly to the computer's USB port. Language selection screen appears when the camera is turned on. 1)You did not configure initial settings after purchasing the camera or the battery may have been left with a dead battery. Check the camera setup (pages 17, 145). 2)There may be a problem with the camera's memory data. If this is the case, perform the reset operation to initialize the camera's setup (page 148). After that, configure each setting. If the language selection screen does not re-appear when you turn the camera on, it means that the camera's memory management data has been restored. If the same message appears after you turn power back on, contact your retailer or a CASIO authorized service center. The time and date settings configured the first time after purchasing the camera are reset to their factory defaults when remove the camera's battery. Load the camera's battery and reconfigure the time and date settings (page 17). Do not remove the battery from the camera for at least 24 hours after configuring time and date settings. After that, the settings will not be reset if you remove the battery. • If the time and date are reset to their factory default settings when you remove the battery after it has been loaded for more than 24 hours, it could mean that the camera's setting memory is defective. Contact your retailer or a CASIO authorized service center. Display Messages ALERT Battery is low. Cannot correct image! Cannot find the file. Cannot register any more files. The camera's protection function may have activated because camera temperature is too high. Turn off the camera and wait until it cools down before trying to use it again. Battery power is low. Keystone correction of the image cannot be performed for some reason. The image will be stored as-is, without correction (page 60). The image you specified with the slideshow "Images" setting cannot be found. Change the "Images" setting (page 93) and try again. You are attempting to save a user BEST SHOT scene in the "SCENE" folder when the folder already contains 999 user scenes (page 57). 171 Appendix