Celestron NexStar 8SE Computerized Telescope NexStar 6 SE and 8 SE Manual - Page 9
Attaching the NexStar to the Tripod, Center Support, Center Leg, Brace, Accessory Tray, Leg Brace
View all Celestron NexStar 8SE Computerized Telescope manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Attaching the NexStar to the Tripod The Celestron NexStar tripod is a sturdy, heavy duty mount on which to place your NexStar 6/8" telescope. This tripod can go anywhere, from your backyard to a remote observing site. The tripod comes completely assembled and only needs to have the center leg brace / accessory tray put in place. To set up the tripod: 1. Hold the tripod with the head up, away from the ground. 2. Pull the legs apart until the legs are fully extended and press it down flat against the ground. 3. Place the center leg brace over the center support rod. 4. Tighten with the leg brace locking knob until the leg brace firmly presses out against each leg. 5. The tripod will now stand by itself. Your tripod has height adjustable legs for proper leveling on all types of surfaces. The tripod also comes with detached bubble level to assist in accurate leveling. To adjust the height and level the tripod: 1. Place the bubble level on the top of the tripod mounting plate. Telescope Mounting Bolts Center Support Rod Center Leg Brace / Accessory Tray Leg Brace Locking Knob 2. Locate the tightening screw on the bottom of each tripod leg. 3. Rotate the knob counterclockwise until the inside portion of the tripod leg slides out. 4. Extend the center portion of the tripod leg to the desired height making sure that the bubble in the bubble level is centered. Tripod Leg Locking Screw Figure 3-5 5. Tighten the knob to hold the tripod leg in place. To mount the telescope on the tripod: 1. Set the base of the telescope on the tripod mounting plate so that the hole in the center of the base goes over the positioning pin on top of the tilt plate. 2. Rotate the base so the holes under each rubber foot line up with the mounting bolts attached to the tilt plate. 3. Thread in the mounting bolts into each hole of the telescope base. Your NexStar is now securely attached to the tripod and ready for use. 9